CR0805F1000FT Datasheet, PDF (1/3 Pages) IRC - a TT electronics Company. – Surface Mount Resistor

Surface Mount
Resistor
CR Series
• 0 ohm available
• Shorting links available
• 1.0 ohms to 100M ohms
• Tolerance down to 0.25%
• Solder terminations have a nickel barrier layer
• Any resistance value available within specified range
Wrap-around
terminations for
soldering
Organic Protection
Tin/lead Solder
Nickel
Thick Film Conductor
Electrical Data
IRC
Type
Power
Rating
at
70°C
(watts)
5%
Tol.
Resistance Range (ohms)
2%
1%
0.5% 0.25%
Tol. Tol.
Tol.
Tol.
Limiting
Element
Voltage
(volts)
TCR -55°C to
+125°C
(ppm/°C)
Values
Thermal
Impedance**
(°C/watt)
<10Ω 350;
CR0805 0.1 1-100M 1-50M 1-20M 1-10M 100-1M 100
10 to 100Ω ^{E24 & E96}
360
preferred
200; 100 to
(any value to
CR1206 0.25 1-100M 1-50M 1-20M 1-10M 100-1M 200
1MΩ 100:
order)
200
>1MΩ 250
* For 10 devices mounted on 50x25mm p.c.b. area
** Zerohm is available
Operating
Temp.
Range
(°C)
-55 to 125
Contruction:
Thick film resistor material, overglaze and organic protection are screen
printed on a 96% alumina substrate.
Terminations:
Wrap-around terminations on CR resistors have good ‘leach’ resistance
properties. They will withstand immersion in solder at 260°C for 30
seconds.
Marking:
All relevant information is recorded on the primary package or reel.
Thickness:
The thickness of these devices depend on the size of the chip.
The table below shows the standard substrate thickness used
(mm).
STYLE
0805 1206
Planar
0.4
0.5
Wrap-around
0.4
0.5
F = Wrap-around; G = Planar Gold.
Electrical Data
Load at rated power: 1000 hours at 70°C
Shelf life: 12 months at room temperature
Derating from rated power at 70°C
Long term damp heat
Temperature rapid change
Resistance to solder heat
Voltage proof
Requirements
∆R%
∆R%
∆R%
∆R%
∆R%
volts
2 (5 above 3M3)
zero at 125°C
2
1
2.5
Maximum
1
Actual
Typical
0.25
0.1
1
0.25
0.25
0.25
500
General Note
IRC reserves the right to make changes in product specification without notice or liability.
All information is subject to IRC’s own data and is considered accurate at time of going to print.
Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA
Telephone: [phone] • Facsimile: 361 992 3377 • Website: www.irctt.com
A subsidiary of
TT electronics plc
CR Series Issue March 2009 Sheet 1 of 3