LME49811 Datasheet, PDF (5/18 Pages) Intersil Corporation – High Fidelity 200 Volt Power Amplifier Input Stage with Shutdown

Symbol
A_V
V_OM
V_NOISE
I_OUT
I_SD
SR
V_OS
I_B
PSRR
Parameter
Conditions
Open Loop Gain
Output Voltage Swing
Output Noise
Output Current
V_IN = 1mV_RMS, f = 1kHz
f = DC
THD+N = 0.05%, Freq = 20Hz to 20kHz
LPF = 30kHz, Av = 29dB
A-weighted
Outputs Shorted
Current into Shutdown Pin
To put part in “play” mode
Slew Rate
Input Offset Voltage
Input Bias Current
Power Supply Rejection Ratio
V_IN = 1.2V_P-P, f = 10kHz square Wave,
Outputs shorted
V_CM = 0V, I_O = 0mA
V_CM = 0V, I_O = 0mA
f = DC, Input Referred
LME49811
Typical
(Note 6)
Limit
(Note 7)
93
120
68
100
70
180
9
7
1.5
1
2
17
14
1
3
100
115
105
Units
(Limits)
dB
dB
V_RMS
μV
μV (max)
mA(min)
mA(min)
mA (max)
V/μs (min)
mV (max)
nA (max)
dB (min)
Note 1: “Absolute Maximum Ratings” indicate limits beyond which damage to the device may occur, including inoperability and degradation of device reliability
and/or performance. Functional operation of the device and/or non-degradation at the Absolute Maximum Ratings or other conditions beyond those indicated in
the Recommended Operating Conditions is not implied. The Recommended Operating Conditions indicate conditions at which the device is functional and the
device should not be operated beyond such conditions. All voltages are measured with respect to the ground pin, unless otherwise specified
Note 2: The Electrical Characteristics tables list guaranteed specifications under the listed Recommended Operating Conditions except as otherwise modified
or specified by the Electrical Characteristics Conditions and/or Notes. Typical specifications are estimations only and are not guaranteed.
Note 3: The maximum power dissipation must be derated at elevated temperatures and is dictated by T_JMAX, θ_JA, and the ambient temperature, T_A. The maximum
allowable power dissipation is P_DMAX = (T_JMAX - T_A) / θ_JA or the number given in Absolute Maximum Ratings, whichever is lower.
Note 4: Human body model, applicable std. JESD22-A114C.
Note 5: Machine model, applicable std. JESD22-A115-A.
Note 6: Typical values represent most likely parametric norms at T_A = +25ºC, and at the Recommended Operation Conditions at the time of product
characterization and are not guaranteed.
Note 7: Datasheet min/max specification limits are guaranteed by test or statistical analysis.
Note 8: The maximum operating junction temperature is 150°C.
Note 9: The Data taken with Bandwidth = 30kHz, A_V = 29dB, C_C = 30pF, and T_A = 25°C except where specified.
5
www.national.com