|
JANSR2N7272 Datasheet, PDF (5/7 Pages) Intersil Corporation – 8A, 100V, 0.180 Ohm, Rad Hard, N-Channel Power MOSFET | |||
|
◁ |
JANSR2N7272
Screening Information
Screening is performed in accordance with the latest revision in effect of MIL-S-19500, (Screening Information Table).
Delta Tests and Limits (JANS) TC = 25oC, Unless Otherwise Speciï¬ed
PARAMETER
SYMBOL
TEST CONDITIONS
MAX
Gate to Source Leakage Current
IGSS
Zero Gate Voltage Drain Current
IDSS
Drain to Source On Resistance
rDS(ON)
Gate Threshold Voltage
VGS(TH)
NOTES:
4. Or 100% of Initial Reading (whichever is greater).
5. Of Initial Reading.
VGS = ±20V
VDS = 80% Rated Value
TC = 25oC at Rated ID
ID = 1.0mA
±20 (Note 4)
±25 (Note 4)
±20% (Note 5)
±20% (Note 5)
UNITS
nA
µA
â¦
V
Screening Information
TEST
Gate Stress
Pind
Pre Burn-In Tests (Note 6)
Steady State Gate Bias (Gate Stress)
Interim Electrical Tests (Note 6)
Steady State Reverse Bias (Drain Stress)
PDA
Final Electrical Tests (Note 6)
NOTE:
6. Test limits are identical pre and post burn-in.
JANS
VGS = 30V, t = 250µs
Required
MIL-S-19500 Group A, Subgroup 2 (All Static Tests at 25oC)
MIL-STD-750, Method 1042, Condition B
VGS = 80% of Rated Value, TA = 150oC, Time = 48 hours
All Delta Parameters Listed in the Delta Tests and Limits Table
MIL-STD-750, Method 1042, Condition A
VDS = 80% of Rated Value, TA = 150oC, Time = 240 hours
5%
MIL-S-19500, Group A,
Subgroups 2 and 3
Additional Screening Tests
PARAMETER
Safe Operating Area
Unclamped Inductive Switching
Thermal Response
Thermal Impedance
SYMBOL
SOA
IAS
âVSD
âVSD
TEST CONDITIONS
VDS = 80V, t = 10ms
VGS(PEAK) = 15V, L = 0.1mH
tH = 10ms; VH = 25V; IH = 2A
tH = 500ms; VH = 25V; IH = 1A
MAX
1.50
24
92
190
UNITS
A
A
mV
mV
2-7
|
▷ |