ISL6173_14 Datasheet, PDF (5/20 Pages) Intersil Corporation – Dual Low Voltage Hot Swap Controller

ISL6173
Absolute Maximum Ratings
VBIAS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +5.5V
GTx, CPQ+ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +12V
ENx, RTR/LTCH, SNSx, PGx, FLTx, VSx, CTx, UVx,
SSx, CPQ-, CPVDD. . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 5.5VDC
Output Current . . . . . . . . . . . . . . . . . . . . . . . Short Circuit Protected
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7) . . .1750V
Machine Model (Per EIAJ ED-4701 Method C-111) . . . . . . . .125V
Charged Device Model (Per EOS/ESD DS5.3, 4/14/93) . . .1750V
Thermal Information
Thermal Resistance (Typical, Notes 1, 4) θ_JA (°C/W) θ_JC (°C/W)
5x5 QFN Package . . . . . . . . . . . . . . . .
42
12.5
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . . -65°C to 150°C
For recommended soldering conditions, see Tech Brief TB389.
(QFN - Leads Only)
Operating Conditions
VBIAS/VIN1 Supply Voltage Range. . . . . . . . . . . . +2.25V to +3.63V
Temperature Range (T_A) . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 85°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θ_JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Tech Brief TB379.
2. All voltages are relative to GND, unless otherwise specified.
3. 1V (min) on the BIAS pin required for FLT to be valid.
4. For θ_JC, the “case temp” location is the center of the exposed metal pad on the package underside.
Electrical Specifications
PARAMETER
V_DD = 2.5V to +3.3V, V_S = 1V ,T_A = T_J = 0°C - 85°C, Unless Otherwise Specified.
SYMBOL
TEST CONDITIONS
MIN
TYP
CURRENT REGULATION CONTROL
ISET Current
Partial Temp Range I_SET Current
Current Limit Amp Offset Voltage
Partial Temp. Current Limit Amp Offset
Voltage
Current Regulation Threshold Voltage
Current Regulation Accuracy
Current Regulation Threshold Voltage
Current Regulation Accuracy
Current Regulation Threshold Voltage
Current Regulation Accuracy
CT Threshold Voltage
CT Charging Current
GATE DRIVE
I_{SET_ft}
I_{SET_pt}
Vio_ft
Vio_pt
V_{CRVTH_1}
V_{CRVTH_1}R
V_{CRVTH_2}
V_{CRVTH_2}R
V_{CRVTH_3}
V_{CRVTH_3}R
V_{CT_Vth}
I_CT
R_OCREF = 14.7kΩ
R_OCREF = 14.7kΩ
T_J = 25^oC to 60^oC
V_VS - V_SNS with I_OUT = 0A
V_VS - V_SNS with I_OUT = 0A
T_J = 25°C to 60°C
RISET = 1.25K, I_SET = 20µA
RISET = 1.25K, I_SET = 20µA
RISET = 2.50K, I_SET = 20µA
RISET = 2.50K, I_SET = 20µA
RISET = 0.499K, I_SET = 20µA
RISET = 0.499K, I_SET = 20µA
18.7
19
-2
-1
23
-8
48
-4
8
-20
1.128
20
20
25
50
10
1.178
10
GATE Response Time from WOC (Open) pd_woc_open GATE open
3
100mV of overdrive on the WOC
comparator
GATE Response Time from WOC
pd_woc_load GATE = 1nF
100
(Loaded)
GATE Response Time in Current
pd_cr_load GATE = 1nF
5
Regulation mode (Loaded)
120% Load Current
GATE Turn-On Current
IGATE
GATE = 2V, V_VS = 2V, V_SNS = 2.1V
21
24
MAX UNIT
21.3
µA
21
µA
2
mV
1
mV
27
mV
+8
%
52
mV
+4
%
12
mV
+20
%
1.202
V
µA
ns
ns
µs
27
µA
5
FN9186.3
January 3, 2006