HWB3163-EVAL Datasheet, PDF (5/6 Pages) Intersil Corporation – PRISM II™ 11Mbps Wireless Local Area Network PC Card

HWB3163-EVAL
Electrical Specifications Test Conditions: Supply Voltage (V_CC) = 3.3V, Ambient Temperature (T_A) = 25^oC,
Unless Otherwise Specified (Continued)
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
TYP
Receive Sensitivity
RX_S
5.5Mbps, 8% PER or 1E-5 BER
-
-87
11Mbps, 8% PER or 1E-5 BER
-
-84
Maximum Receive Level
RX_MAX PER <8%
-4
-
Third Order Intercept Point (Input)
IIP3_90 -90 dBm input
-16
-3
IIP3_25 -25 dBm input
+10
+20
Image Rejection
IR
PER <8%
-
60
IF Rejection
IFR
PER <8%
60
100
Adjacent Channel Rejection
ACR
PER <8% (Note 6)
-
46
Data Rate (Physical Layer)
Rate
- 1, 2, 5.5
and 11
NOTES:
5. Refer to Application Note “PRISM Power Management Modes” AN9665 [5].
6. The adjacent channel measurement is carried out on two channels separated by 25MHz (5 channels).
MAX
-
-
-
-
-
-
-
-
-
UNITS
dBm
dBm
dBm
dBm
dBm
dB
dB
dB
Mbps
PIN 34
TOP (LED, THIS SIDE)
PIN 1
3V KEY
PIN 68
BOTTOM
PIN 35
VIEW, LOOKING INTO 68 PIN FEMALE CONNECTOR
FIGURE 1. EDGE VIEW, PCMCIA CARD
Back PC Card Label
References
For Intersil documents available on the internet, see web site
http://www.intersil.com/
Intersil AnswerFAX [phone].
[1] TB337 Tech Brief, Intersil Corporation, “A Brief Tutorial
on Spread Spectrum and Packet Radio”, AnswerFAX
document No. 82337.
[2] AN9864 Application Note, Intersil Corporation,
“HWB3163-EVAL PRISM II 11Mbps WLAN PCMCIA
Card User’s Guide”
Further information can be found in the following:
• Intersil PRISM II datasheets, web home page,
http://www.intersil.com/prism/prism.asp
• IEEE 802.11 Standards Project (available from the
IEEE, New York, USA).
• PC Card V2.1 Standard.
5