English
Language : 

ISL54063_0911 Datasheet, PDF (4/15 Pages) Intersil Corporation – Negative Signal Swing, Sub-ohm, Dual SPST
◁
ISL54063, ISL54064
Absolute Maximum Ratings
V+ to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 7.0V
Input Voltages
NOx, NCx (Note 5) . . . . . . . . . . . . . . . . (V+ - 7V) to ((V+) + 0.5V)
INx (Note 5) . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to ((V+) + 0.5V)
Output Voltages
COMx (Note 5) . . . . . . . . . . . . . . . . . . . (V+ - 7V) to ((V+) + 0.5V)
Continuous Current NOx, NCx, or COMx . . . . . . . . . . . . . . ±300mA
Peak Current NOx, NCx, or COMx
(Pulsed 1ms, 10% Duty Cycle, Max) . . . . . . . . . . . . . . . . . . ±500mA
ESD Rating:
Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>6kV
Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>400V
Charged Device Model. . . . . . . . . . . . . . . . . . . . . . . . . . . . >1.5kV
Thermal Information
Thermal Resistance (Typical)
θJA (°C/W) θJC (°C/W)
10 Ld 3x3 TDFN Package (Notes 6, 8)
55
18
10 Ld µTQFN Package (Note 7) . . . . . 155
N/A
Maximum Junction Temperature (Plastic Package). . . . . . . +150°C
Maximum Storage Temperature Range . . . . . . . . . . . -65°C to +150°C
Pb-Free Reflow Profile. . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +85°C
Power Supply Range . . . . . . . . . . . . . . . . . . . . . . . . +1.8V to +6.5V
AUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTES:
5. Signals on NC, NO, IN, or COM exceeding V+ or GND by the specified amount are clamped by internal diodes. Limit forward diode current to
maximum current ratings.
6. θJA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Tech Brief TB379.
7. θJA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
8. For θJC, the “case temp” location is the center of the exposed metal pad on the package underside.
Electrical Specifications - 5V Supply Test Conditions: V+ = +4.5V to +5.5V, GND = 0V, VINH = 2.4V, VINL = 0.8V (Note 9), Unless
Otherwise Specified.
PARAMETER
TEST CONDITIONS
TEMP
MIN
MAX
(°C) (Notes 10, 11) TYP (Notes 10, 11) UNITS
ANALOG SWITCH CHARACTERISTICS
ON-Resistance, rON
V+ = 4.5V, ICOM = 100mA, VNO or VNC = (V+ -
25
-
0.55
-
Ω
6.5) to V+ (see Figure 4)
Full
-
0.68
-
Ω
rON Matching Between Channels, V+ = 4.5V, ICOM = 100mA, VNO or VNC = Voltage 25
-
15
-
mΩ
ΔrON
at max rON, (Note 13)
Full
-
30
-
mΩ
rON Flatness, RFLAT(ON)
V+ = 4.5V, ICOM = 100mA, VNO or VNC = (V+ -
25
-
0.11
-
Ω
6.5) to V+, (Note 12)
Full
-
0.14
-
Ω
COM ON Leakage Current,
V+ = 5V, VCOM = -1.5V, 5V, VNO or VNC = Float
25
-
49
-
nA
ICOM(ON)
Full
-
0.7
-
µA
DYNAMIC CHARACTERISTICS
Turn-ON Time, tON
V+ = 4.5V, VNO or VNC = 3.0V, RL = 50Ω,
25
CL = 35pF (see Figure 1)
Full
Turn-OFF Time, tOFF
V+ = 4.5V, VNO or VNC = 3.0V, RL = 50Ω,
25
CL = 35pF (see Figure 1)
Full
Charge Injection, Q
OFF-Isolation
VG = 0V, RG = 0Ω, CL = 1.0nF (see Figure 2)
25
RL = 50Ω, CL = 5pF, f = 100kHz, VCOM = 1VRMS 25
(see Figure 3)
Crosstalk (Channel-to-Channel)
RL = 50Ω, CL = 5pF, f = 1MHz, VCOM = 1VRMS
25
(see Figure 5)
Total Harmonic Distortion
-3dB Bandwidth
f = 20Hz to 20kHz, VCOM = 0.5VP-P, RL = 32Ω
25
VCOM = 1VRMS, RL = 50Ω, CL = 5pF
25
NO x or NCx OFF Capacitance,
f = 1MHz
25
COFF
COMx ON Capacitance, CCOM(ON) f = 1MHz (See Figure 6)
25
-
35
-
ns
-
30
-
ns
-
10
-
ns
-
15
-
ns
-
170
-
pC
-
60
-
dB
-
-75
-
dB
-
0.02
-
%
-
60
-
MHz
-
36
-
pF
-
88
-
pF
4
FN6582.1
November 3, 2009
 ▷