English
Language : 

ISL2110 Datasheet, PDF (4/13 Pages) Intersil Corporation – 100V, 3A/4A Peak, High Frequency Half-Bridge Drivers
ISL2110, ISL2111
Absolute Maximum Ratings
Supply Voltage, VDD, VHB - VHS (Notes 4, 5) . . . . . . . . -0.3V to 18V
LI and HI Voltages (Note 5) . . . . . . . . . . . . . . . . -0.3V to VDD + 0.3V
Voltage on LO (Note 5) . . . . . . . . . . . . . . . . . . . -0.3V to VDD + 0.3V
Voltage on HO (Note 5) . . . . . . . . . . . . . . VHS - 0.3V to VHB + 0.3V
Voltage on HS (Continuous) (Note 5) . . . . . . . . . . . . . . -1V to 110V
Voltage on HB (Note 5) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 118V
Average Current in VDD to HB Diode . . . . . . . . . . . . . . . . . . 100mA
Maximum Recommended Operating Conditions
Supply Voltage, VDD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8V to 14V
Voltage on HS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1V to 100V
Voltage on HS . . . . . . . . . . . . . . .(Repetitive Transient) -5V to 105V
Voltage on HB. . . . .VHS+7V to VHS+14V and VDD - 1V to VDD+100V
HS Slew Rate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <50V/ns
Thermal Information
Thermal Resistance (Typical)
θJA (°C/W) θJC (°C/W)
8 Ld SOIC (Notes 6, 10). . . . . . . . . . . .
95
46
10 Ld TDFN (Notes 7, 8) . . . . . . . . . . .
42
5.5
12 Ld DFN (Notes 7, 8) . . . . . . . . . . . .
40
5.5
8 Ld DFN (Notes 7, 8) . . . . . . . . . . . . .
40
4.0
Max Power Dissipation at +25°C in Free Air
8 Ld SOIC (Notes 6, 10) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.3W
10 Ld TDFN (Notes 7, 8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.0W
12 Ld DFN (Notes 7, 8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.1W
8 Ld DFN (Notes 7, 8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.1W
Storage Temperature Range . . . . . . . . . . . . . . . . . . . -65°C to +150°C
Junction Temperature Range. . . . . . . . . . . . . . . . . .-55°C to +150°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTES:
4. The ISL2110 and ISL2111 are capable of derated operation at supply voltages exceeding 14V. Figure 22 shows the high-side voltage derating
curve for this mode of operation.
5. All voltages referenced to VSS unless otherwise specified.
6. θJA is measured in free air with the component mounted on a high effective thermal conductivity test board. See Tech Brief TB379 for details.
7. θJA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Tech Brief TB379.
8. For θJC, the “case temp” location is the center of the exposed metal pad on the package underside.
9. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
10. For θJC, the “case temp” location is taken at the package top center.
Electrical Specifications
PARAMETERS
VDD = VHB = 12V, VSS = VHS = 0V, No Load on LO or HO, unless otherwise specified.
TJ = +25°C
TJ = -40°C to +125°C
SYMBOL
TEST CONDITIONS
MIN
MAX
MIN TYP MAX (Note 9) (Note 9) UNITS
SUPPLY CURRENTS
VDD Quiescent Current
VDD Quiescent Current
VDD Operating Current
VDD Operating Current
Total HB Quiescent Current
Total HB Operating Current
HB to VSS Current, Quiescent
HB to VSS Current, Operating
INPUT PINS
IDD
IDD
IDDO
IDDO
IHB
IHBO
IHBS
IHBSO
ISL2110; LI = HI = 0V
ISL2111; LI = HI = 0V
ISL2110; f = 500kHz
ISL2111; f = 500kHz
LI = HI = 0V
f = 500kHz
LI = HI = 0V; VHB = VHS = 114V
f = 500kHz; VHB = VHS = 114V
-
0.1 0.25
-
-
0.3 0.45
-
-
3.4 5.0
-
-
3.5 5.0
-
-
0.1 0.15
-
-
3.4 5.0
-
- 0.05 1.5
-
-
1.2
-
-
0.3
mA
0.55
mA
5.5
mA
5.5
mA
0.2
mA
5.5
mA
10
µA
-
mA
Low Level Input Voltage Threshold
Low Level Input Voltage Threshold
High Level Input Voltage Threshold
High Level Input Voltage Threshold
Input Voltage Hysteresis
Input Pull-Down Resistance
VIL
VIL
VIH
VIH
VIHYS
RI
ISL2110
ISL2111
ISL2110
ISL2111
ISL2110
3.7 4.4
-
3.5
-
V
1.4 1.8
-
1.2
-
V
-
6.6 7.4
-
7.6
V
-
1.8 2.2
-
2.4
V
-
2.2
-
-
-
V
- 210 -
100
500
kΩ
4
FN6295.6
March 8, 2012