HA-5222 Datasheet, PDF (4/8 Pages) Intersil Corporation – Dual, Low Noise, Wideband, Precision Operational Amplifier

Specifications HA-5222/883
TABLE 3. ELECTRICAL PERFORMANCE CHARACTERISTIC (Continued)
Device Characterized at: V_SUPPLY = ±15V, R_LOAD = 1kΩ, Unless Otherwise Specified.
LIMITS
PARAMETERS
SYMBOL
CONDITIONS
NOTES
TEMPERATURE MIN
MAX UNITS
Minimum Closed Loop
Stable Gain
CLSG R_L = 1kΩ, C_L = 50pF
1
-55^oC to +125^oC
1
-
V/V
Rise and Fall Time
t_R, t_F
V_OUT = ±100mV
1, 4
+25^oC
-
-55^oC to +125^oC
-
20
ns
35
ns
Overshoot
±OS
V_OUT = ±100mV
1
+25^oC
-
25
%
-55^oC to +125^oC
-
30
%
Power Consumption
PC
V_OUT = 0V, I_OUT = 0mA
1, 3
-55^oC to +125^oC
-
660
mW
NOTES:
1. Parameters listed in Table 3 are controlled via design or process parameters and are not directly tested at final production. These param-
eters are lab characterized upon initial design release, or upon design changes. These parameters are guaranteed by characterization
based upon data from multiple production runs which reflect lot to lot and within lot variation.
2. Full Power Bandwidth guarantee based on Slew Rate measurement using FPBW = Slew Rate/(2πV_PEAK).
3. Power Consumption based upon Quiescent Supply Current test maximum. (No load on outputs.).
4. Measured between 10% and 90% points.
5. Input Noise Voltage Density and Input Noise Current Density limits are based on characterization data.
TABLE 4. ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
SUBGROUPS (SEE TABLE 1)
Interim Electrical Parameters (Pre Burn-In)
1
Final Electrical Test Parameters
1 (Note 1), 2, 3, 4, 5, 6
Group A Test Requirements
1, 2, 3, 4, 5, 6
Groups C and D Endpoints
1
NOTE:
1. PDA applies to Subgroup 1 only.
3-172
Spec Number 511062-883