English
Language : 

HA-5114 Datasheet, PDF (4/5 Pages) Intersil Corporation – Quad, Low Noise, High Performance Uncompensated Operational Amplifier
Specifications HA-5114/883
TABLE 3. ELECTRICAL PERFORMANCE CHARACTERISTICS (Continued)
Device Characterized at: VSUPPLY = ±15V, RLOAD = 2kΩ, CLOAD = 50pF, AVCL = 10V/V, Unless Otherwise Specified.
LIMITS
PARAMETERS
Slew Rate
Full Power Bandwidth
Minimum Closed Loop
Stable Gain
Rise and Fall Time
Overshoot
Output Resistance
Quiescent Power
Consumption
Channel Separation
SYMBOL
+SR
-SR
FPBW
CLSG
CONDITIONS
VOUT = -5V to +5V
VOUT = +5V to -5V
VPEAK = 10V
RL = 2kΩ, CL = 50pF
tR
tF
+OS
-OS
ROUT
PC
VOUT = 0V to +200mV
VOUT = 0V to -200mV
VOUT = 0V to +200mV
VOUT = 0V to -200mV
Open Loop
VOUT = 0V, IOUT = 0mA
CS
RS = 1kΩ,
AVCL = 100V/V,
VIN = 100mVPEAK at
10kHz Referred to
Input
NOTES
1
1
1, 2
1
1, 4
1, 4
1
1
1
1, 3
1
TEMPERATURE MIN
+25oC
12
+25oC
12
+25oC
191
-55oC to +125oC
10
+25oC
-
+25oC
-
+25oC
-
+25oC
-
+25oC
-
-55oC to +125oC
-
+25oC
55
MAX
-
-
-
-
UNITS
V/µs
V/µs
kHz
V/V
100
ns
100
ns
40
%
40
%
270
Ω
225
mW
-
dB
NOTES:
1. Parameters listed in Table 3 are controlled via design or process parameters and are not directly tested at final production. These param-
eters are lab characterized upon initial design release, or upon design changes. These parameters are guaranteed by characterization
based upon data from multiple production runs which reflect lot to lot and within lot variation.
2. Full Power Bandwidth guarantee based on Slew Rate measurement using FPBW = Slew Rate/(2πVPEAK).
3. Quiescent Power Consumption based upon Quiescent Supply Current test maximum. (No load on outputs.).
4. Measured between 10% and 90% points.
TABLE 4. ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
SUBGROUPS (SEE TABLE 1)
Interim Electrical Parameters (Pre Burn-In)
1
Final Electrical Test Parameters
1 (Note 1), 2, 3, 4, 5, 6
Group A Test Requirements
1, 2, 3, 4, 5, 6
Groups C and D Endpoints
1
NOTE:
1. PDA applies to Subgroup 1 only.
3-127
Spec Number 511015-883