ISL6121_14 Datasheet, PDF (3/11 Pages) Intersil Corporation – Single Supply Integrated Current Limiting Controller

ISL6121
Absolute Maximum Ratings
Supply Voltage (V+ to V-). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.0V
EN, FAULT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 6V
OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GND-0.3V to VIN +0.3V
DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_SUPPLY
Output Current . . . . . . . . . . . . . . . . . . . . . . .Short Circuit Protected
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7) . . . . 3KV
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W)
8 Lead SOIC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
116
Maximum Junction Temperature (Plastic Package) . . . . . . . .150^oC
Maximum Storage Temperature Range . . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300^oC
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . -40^oC to 85^oC
Supply Voltage Range (Typical) . . . . . . . . . . . . . . . . . . 2.5V to 5.5V
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
Electrical Specifications V_SUPPLY = 5V, Unless Otherwise Specified.
PARAMETER
SYMBOL
TEST CONDITIONS
POWER SWITCH
ISL6121 On Resistance at 2.7V
ISL6121 On Resistance at 3.3V
ISL6121 On Resistance at 5.0V
Disabled Output Voltage
Output Voltage Rising Rate
Slow VOUT Turn-off Rate
Fast VOUT Turn-off Rate
CURRENT CONTROL
r_{DS(ON)_27}
r_{DS(ON)_33}
r_{DS(ON)_50}
V_{OUT_DIS}
t_vout_rt
t_svout_offt
t_fvout_offt
VIN = 2.7V, IOUT = 0.8A, T_A = T_J = 25^oC
T_A = T_J = 85^oC
VIN = 3.3V, IOUT = 0.8A, T_A = T_J = 25^oC
T_A = T_J = 85^oC
VIN = 5V, IOUT = 0.8A, T_A = T_J = 25^oC
T_A = T_J = 85^oC
VIN = 5V, Switch Disabled, 50µA Load
R_L = 10Ω, C_L = 0.1µF, 10%-90%
R_L = 10Ω, C_L = 0.1µF, 90%-10%
R_L = 1Ω, C_L = 0.1µF, 90%-10%
Current Limit, VIN = 5V
Ilim
VOUT = 3.3V
OC Regulation Settling Time
Severe OC Regulation Settling Time
Over Current Latch-off Time
I/O PARAMETERS
tsett_Ilim R_L = 1.6Ω, C_L = 0.1µF to Within 10% of CR
tsett_{Ilim_sev} R_L< 1Ω, C_L = 0.1µF to Within 10% of CR
t_{OC_loff} T_J = 25^oC
Fault Output Voltage
Vfault Fault Output Current = 10mA
ENABLE High Threshold
Ven_vih VIN = 5.5V
ENABLE Low Threshold
Ven_vil VIN = 2.7V
ENABLE Low Threshold
ENABLE Input Current
BIAS PARAMETERS
Enabled VIN Current
Disabled VIN Current
Under Voltage Lockout Threshold
UV Hysteresis
Over Temperature Disable
Ven_vil
Ien_i
VIN = 4.5V
ENABLE = 0V to 5V, VIN = 5V, T_J >25^oC
I_VDD
I_VDD
V_UVLH
UV_HYS
Temp_dis
Switch Closed, OUTPUT = OPEN, T_J > 0^oC
Switch Open, OUTPUT = OPEN
VIN Rising, Switch Enabled
MIN
TYP
MAX UNITS
-
60
70
mΩ
-
-
80
mΩ
-
50
60
mΩ
-
-
75
mΩ
-
50
60
mΩ
-
-
75
mΩ
-
300
450
mV
-
10
-
V/ms
-
10
-
V/ms
-
3
-
V/µs
1.5
2
2.5
A
-
1
-
ms
-
100
-
µs
-
12
-
ms
-
-
2.0
-
-
-
-
-
-0.5
0
0.4
V
-
V
0.6
V
0.8
V
0.5
µA
-
120
200
µA
-
-
5
µA
1.7
2.25
2.5
V
50
100
-
mV
-
150
-
o_C
3
FN9004.2
November 12, 2004