ISL28276_07 Datasheet, PDF (3/13 Pages) Intersil Corporation – Dual and Quad Precision Micropower Single Supply Rail-to-Rail Input and Output Precision Op Amps

ISL28276, ISL28476
Absolute Maximum Ratings (T_A = +25°C)
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.5V, 1V/μs
Differential Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . V_- - 0.5V to V₊ + 0.5V
ESD tolerance, Human Body Model . . . . . . . . . . . . . . . . . . . . . .3kV
ESD tolerance, Machine Model . . . . . . . . . . . . . . . . . . . . . . . . .300V
Thermal Information
Output Short-Circuit Duration . . . . . . . . . . . . . . . . . . . . . . .Indefinite
Ambient Operating Temperature Range . . . . . . . . .-40°C to +125°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . +125°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical ^{OperatingJunction} Specifications V₊ = 5V, 0V, V_CM = 0.1V, V_O = 1.4V, T_A = +25°C unless otherwise specified.
Boldface limits apply over the operating temperature range, -40°C to +125°C
PARAMETER
DESCRIPTION
CONDITIONS
MIN TYP
V_OS
--^Δ----^V----^O-----^S---
ΔTime
Δ_-----V_----O----S--
ΔT
Input Offset Voltage
Long Term Input Offset Voltage Stability
Input Offset Drift vs Temperature
-100
20
-150
1.2
0.3
I_OS
Input Offset Current
0.25
I_B
e_N
i_N
CMIR
CMRR
PSRR
A_VOL
V_OUT
Input Bias Current
Input Noise Voltage Peak-to-Peak
Input Noise Voltage Density
Input Noise Current Density
Input Voltage Range
Common-Mode Rejection Ratio
Power Supply Rejection Ratio
Large Signal Voltage Gain
Maximum Output Voltage Swing
f = 0.1Hz to 10Hz
f_O = 1kHz
f_O = 1kHz
Guaranteed by CMRR test
V_CM = 0V to 5V
V₊ = 2.4V to 5V
V_O = 0.5V to 4.5V, R_L = 100kΩ
V_O = 0.5V to 4.5V, R_L = 1kΩ
Output low, R_L = 100kΩ
-2
0.5
-2.5
1
25
0.1
0
90
115
80
90
115
80
350
550
350
25
3
Output low, R_L = 1kΩ
130
SR+
SR-
GBW
Positive Slew Rate
Negative Slew Rate
Gain Bandwidth Product
Output high, R_L = 100kΩ
Output high, R_L = 1kΩ
4.990
4.97
4.800
4.750
0.13
0.10
0.10
0.09
4.996
4.880
0.17
0.13
400
MAX
100
150
UNIT
µV
µV/Mo
µV/°C
1.3
nA
2.0
2
nA
2.5
µV_P-P
nV/√Hz
pA/√Hz
5
V
dB
dB
V/mV
V/mV
6
mV
30
175
mV
225
V
V
0.20 V/µs
0.25
0.17 V/µs
0.19
kHz
3
FN6301.1
April 20, 2007