ISL28191_0808 Datasheet, PDF (3/16 Pages) Intersil Corporation – Low Distortion Rail-to-Rail Output, Op Amp

ISL28191, ISL28291
Absolute Maximum Ratings (T_A = +25°C)
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5V
Supply Turn On Voltage Slew Rate . . . . . . . . . . . . . . . . . . . . . 1V/µs
Differential Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . V- - 0.5V to V+ + 0.5V
ESD Tolerance
Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3kV
Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .300V
Charged Device Model (CDM) . . . . . . . . . . . . . . . . . . . . . . .1200V
Thermal Information
Thermal Resistance (Typical, Note )
θ_JA (°C/W)
6 Ld SOT-23 Package . . . . . . . . . . . . . . . . . . . . . . .
230
6 Ld µTDFN Package . . . . . . . . . . . . . . . . . . . . . . .
125
8 Ld SO Package . . . . . . . . . . . . . . . . . . . . . . . . . . .
125
10 Ld MSOP Package . . . . . . . . . . . . . . . . . . . . . . .
150
10 Ld µTQFN Package . . . . . . . . . . . . . . . . . . . . . .
180
Ambient Operating Temperature Range . . . . . . . . .-40°C to +125°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +125°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
3. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications
V+ = 5.0V, V- = GND, R_L = Open, R_F = 1kΩ, A_V = -1 unless otherwise specified. Parameters are per amplifier.
Typical values are at V+= 5V, T_A = +25°C. Boldface limits apply over the operating temperature range,
-40°C to +125°C, temperature data guaranteed by characterization.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
MAX
(Note 4) TYP (Note 4) UNIT
DC SPECIFICATIONS
V_OS
-^Δ----^V_Δ----^O_T----^S--
I_IO
Input Offset Voltage
Input Offset Drift vs Temperature Figure 21
Input Offset Current
270
630
µV
840
3.1
µV/°C
35
500
nA
900
I_B
Input Bias Current
3
6
µA
7
CMIR
Common-Mode Input Range
0
3.8
V
CMRR
PSRR
A_VOL
Common-Mode Rejection Ratio
Power Supply Rejection Ratio
Large Signal Voltage Gain
V_CM = 0V to 3.8V
V_S = 3V to 5V
V_O = 0.5V to 4V, R_L = 1kΩ
78
100
dB
74
80
dB
90
98
dB
86
V_OUT
Maximum Output Voltage Swing
Output low, R_L = 1kΩ
20
50
mV
80
Output high, R_L = 1kΩ, V+ = 5V
4.95 4.97
V
4.92
I_S,ON
Supply Current per Amplifier,
Enabled
2.6
3.5
mA
3.9
I_S,OFF
Supply Current per Amplifier,
Disabled
26
35
µA
48
I_O+
Short-Circuit Output Current
R_L = 10Ω
95
130
mA
90
I_O-
Short-Circuit Output Current
R_L = 10Ω
95
130
mA
90
V_SUPPLY
V_ENH
Supply Operating Range
EN High Level
V+ to V-
Referred to V-
3
5.5
V
2
V
3
FN6156.7
August 11, 2008