ISL1532IRZ Datasheet, PDF (3/19 Pages) Intersil Corporation – Dual Channel Differential DSL Line Driver

ISL1532
Absolute Maximum Ratings (T_A = +25°C)
V_S+ to V_S- Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . -0.3V to 30V
V_S+ Voltage to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 30V
V_S- Voltage to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . -30V to 0.3V
Driver V_IN+ Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_S- to V_S+
C₀, C₁ Voltage to GND . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 6V
I_ADJ Voltage to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 4V
Current into any Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8mA
Output Current from Driver (Static) . . . . . . . . . . . . . . . . . . . . . 50mA
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Curves
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Temperature Range . . . . . . . . . . . . . . . . .-40°C to +85°C
Operating Junction Temperature . . . . . . . . . . . . . . .-40°C to +150°C
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7). . . . . . .3kV
Machine Model (Per EIAJ ED-4701 Method C-111) . . . . . . . . .250V
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests are at the
specified temperature and are pulsed tests, therefore: T_J = T_C = T_A.
Electrical Specifications V_S = ±12V, R_F = 3kΩ, R_L= 65Ω, I_ADJ = C₀ = C₁ = 0V, T_A = +25°C. Amplifiers tested separately.
PARAMETER
DESCRIPTION
CONDITIONS
MIN TYP MAX
UNIT
SUPPLY CHARACTERISTICS
I_S+ (Full I_S)
Positive Supply Current per Amplifier All outputs at 0V, C₀ = C₁ = 0V, R_ADJ = 0
3.75
4.9
6.5
mA
I_S- (Full I_S)
Negative Supply Current per Amplifier All outputs at 0V, C₀ = C₁ = 0V, R_ADJ = 0
-6.3
-4.7
-3.5
mA
I_S+ (3/4 I_S)
Positive Supply Current per Amplifier All outputs at 0V, C₀ = 5V, C₁ = 0V, R_ADJ = 0
3.8
mA
I_S- (3/4 I_S)
Negative Supply Current per Amplifier All outputs at 0V, C₀ = 5V, C₁ = 0V, R_ADJ = 0
-3.5
mA
I_S+ (1/2 I_S)
Positive Supply Current per Amplifier All outputs at 0V, C₀ = 0V, C₁ = 5V, R_ADJ = 0 1.87
2.6
3.75
mA
I_S- (1/2 I_S)
Negative Supply Current per Amplifier All outputs at 0V, C₀ = 0V, C₁ = 5V, R_ADJ = 0 -3.75 -2.4 -1.75 mA
I_S+ (Power-down) Positive Supply Current per Amplifier All outputs at 0V, C₀ = C₁ = 5V, R_ADJ = 0
0.25
1.0
mA
I_S- (Power-down) Negative Supply Current per Amplifier All outputs at 0V, C₀ = C₁ = 5V, R_ADJ = 0
-1.0
0
mA
I_GND
GND Supply Current per Amplifier
All outputs at 0V
0.25
mA
INPUT CHARACTERISTICS
V_OS
ΔV_OS
I_B+
I_B-
ΔI_B-
R_OL
e_N
i_N
V_IH
V_IL
I_IH0, I_IH1
I_IL
Input Offset Voltage
V_OS Mismatch
Non-Inverting Input Bias Current
Inverting Input Bias Current
I_B- Mismatch
Transimpedance
Input Noise Voltage
-Input Noise Current
Input High Voltage
Input Low Voltage
Input High Current for C_0, C₁
Input Low Current for C₀ or C₁
C₀ and C₁ inputs, with signal
C₀ and C₁ inputs, without signal
C₀ and C₁ inputs
C₀ = 5V, C₁ = 5V
C₀ = 0V, C₁ = 0V
-10
1
+10
mV
-5
0
+5
mV
-15
+14
µA
-30
+30
µA
-25
0
+25
µA
1
3.4
8
MΩ
3.5
nV/√ Hz
2
pA/√ Hz
1.8
V
1.6
V
0.8
V
10
20
40
µA
-3.0
-0.3
µA
3
FN6173.3
December 4, 2006