ICL8069 Datasheet, PDF (3/6 Pages) Intersil Corporation – Low Voltage Reference

ICL8069
Absolute Maximum Ratings
Reverse Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Note 3
Forward Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10mA
Reverse Current. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10mA
Operating Conditions
Temperature Ranges
ICL8069C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0^oC to 70^oC
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W) θ_JC (^oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . . 170
N/A
SIP (TO-92) Package. . . . . . . . . . . . . . 200
N/A
Power Dissipation Limited by MAX Forward/Reverse Current
Maximum Junction Temperature (SOIC Package) . . . . . . . . .150^oC
Maximum Storage Temperature Range . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300^oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications T_A = 25^oC Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNITS
Reverse Breakdown Voltage
Reverse Breakdown Voltage Change
Reverse Dynamic Impedance
Forward Voltage Drop
RMS Noise Voltage
Long Term Stability
Breakdown Voltage Temperature Coefficient
ICL8069C
ICL8069D
I_R = 500µA
1.20
50µA ≤ l_R ≤ 5mA
-
l_R = 50µA
-
l_R = 500µA
-
l_F = 500µA
-
10Hz ≤ F ≤ 10kHz, l_R = 500µA
-
l_R = 4.75mA, T_A = 25^oC
-
I_R = 500µA, T_A = Operating
Temperature Range
-
-
1.23
1.25
15
20
1
2
1
2
0.7
1
5
-
1
-
-
0.005
-
0.01
V
mV
Ω
Ω
V
µV
ppm/kHR
%/ ^oC
%/ ^oC
Reverse Current Range
1.18V to 1.27V
0.050
-
5
mA
NOTES:
2. If circuit strays in excess of 200pF are anticipated, a 4.7µF shunt capacitor will ensure stability under all operating conditions.
3. In normal use, the reverse voltage cannot exceed the reference voltage. However when plugging units into a powered-up test fixture, an
instantaneous voltage equal to the compliance of the test circuit will be seen. This should not exceed 20V.
3