EL5210 Datasheet, PDF (3/13 Pages) Intersil Corporation – 30MHz Rail-to-Rail Input-Output Op Amps

EL5210, EL5410
Absolute Maximum Ratings (T_A = 25°C)
Supply Voltage between V_S+ and V_S-. . . . . . . . . . . . . . . . . . . .+18V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . .V_S- -0.5V, V_S +0.5V
Maximum Continuous Output Current . . . . . . . . . . . . . . . . . . . 30mA
Maximum Die Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . +125°C
Storage Temperature. . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Temperature . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Curves
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications V_S+ = +5V, V_S- = -5V, R_L = 1kΩ and C_L = 12pF to 0V, T_A = 25°C unless otherwise specified.
PARAMETER
DESCRIPTION
CONDITION
MIN TYP MAX
INPUT CHARACTERISTICS
V_OS
TCV_OS
I_B
R_IN
C_IN
CMIR
Input Offset Voltage
V_CM = 0V
Average Offset Voltage Drift (Note 1)
Input Bias Current
Input Impedance
V_CM = 0V
Input Capacitance
Common-Mode Input Range
3
15
7
2
60
1
2
-5.5
+5.5
CMRR
Common-Mode Rejection Ratio
A_VOL
Open-Loop Gain
OUTPUT CHARACTERISTICS
for V_IN from -5.5V to 5.5V
-4.5V ≤ V_OUT ≤ 4.5V
50
70
65
80
V_OL
Output Swing Low
V_OH
Output Swing High
I_SC
Short Circuit Current
I_OUT
Output Current
POWER SUPPLY PERFORMANCE
I_L = -5mA
I_L = 5mA
-4.9 -4.8
4.8
4.9
±120
±30
PSRR
Power Supply Rejection Ratio
I_S
Supply Current (Per Amplifier)
DYNAMIC PERFORMANCE
V_S is moved from ±2.25V to ±7.75V
No Load
60
80
2.5
3.75
SR
Slew Rate (Note 2)
-4.0V ≤ V_OUT ≤ 4.0V, 20% to 80%
33
t_S
Settling to +0.1% (A_V = +1)
(A_V = +1), V_O = 2V Step
140
BW
-3dB Bandwidth
30
GBWP
Gain-Bandwidth Product
20
PM
Phase Margin
50
CS
Channel Separation
f = 5MHz
110
d_G
Differential Gain (Note 3)
R_F = R_G = 1kΩ and V_OUT = 1.4V
0.12
d_P
Differential Phase (Note 3)
R_F = R_G = 1kΩ and V_OUT = 1.4V
0.17
UNIT
mV
µV/°C
nA
GΩ
pF
V
dB
dB
V
V
mA
mA
dB
mA
V/µs
ns
MHz
MHz
°
dB
%
°
NOTES:
1. Measured over operating temperature range
2. Slew rate is measured on rising and falling edges
3. NTSC signal generator used
3
FN7185.2
May 6, 2005