English
Language : 

DG211_05 Datasheet, PDF (3/7 Pages) Intersil Corporation – SPST 4-Channel Analog Switch
DG211
Absolute Maximum Ratings
V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44V
VIN to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V- to V+
VL to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 25V
VS or VD to V+ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to -36V
VS or VD to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to 36V
V+ to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25V
V- to Ground. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -25V
Current, any Terminal Except S or D . . . . . . . . . . . . . . . . . . . . 30mA
Continuous Current, S or D . . . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Peak Current, S or D (Pulsed 1ms, 10% Duty Cycle Max) . . . . . 70mA
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C
Thermal Information
Thermal Resistance (Typical, Note 3)
θJA (°C/W)
PDIP Package* . . . . . . . . . . . . . . . . . . . . . . . . . . . .
100
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
120
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . . -65°C to 150°C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300°C
(SOIC - Lead Tips Only)
*Pb-free PDIPs can be used for through hole wave solder
processing only. They are not intended for use in Reflow solder
processing applications.
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
3. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications V+ = +15V, V- = -15V, VL = +5V, GND, TA = 25°C
PARAMETER
DYNAMIC CHARACTERISTICS
Turn-ON Time, tON
Turn-OFF Time,
tOFF1
tOFF2
OFF Isolation, OIRR (Note 7)
Crosstalk (Channel to Channel), CCRR
Source OFF Capacitance, CS(OFF)
Drain OFF Capacitance, CD(OFF)
Channel ON Capacitance, CD(ON) + CS(ON)
DIGITAL INPUT CHARACTERISTICS
Input Current with Voltage High, IIH
Input Current with Voltage Low, IIL
ANALOG SWITCH CHARACTERISTICS
Analog Signal Range, VANALOG
Drain-Source ON Resistance, rDS(ON)
Source OFF Leakage Current, IS(OFF)
Drain OFF Leakage Current, ID(OFF)
Drain ON Leakage Current, ID(ON)
(Note 6)
TEST CONDITIONS
See Figure 1
VS = 10V, RL = 1kΩ, CL = 35pF
VIN = 5V, RL = 1kΩ, CL = 15pF, VS = 1VRMS,
f = 100kHz
VD = VS = 0V, VIN = 5V, f = 1MHz
VIN = 2.4V
VIN = 15V
VIN = 0V
VD = ±10V, IS = 1mA, VIN = 0.8V
VIN = 2.4V
VS = 14V, VD = -14V
VS = -14V, VD = 14V
VS = -14V, VD = 14V
VS = 14V, VD = -14V
VIN = 0.8V
VS = VD = 14V
VS = VD = -14V
(NOTE 4) (NOTE 5)
MIN
TYP
MAX
UNITS
-
460
-
ns
-
360
-
ns
-
450
-
ns
-
70
-
dB
-
-90
-
dB
-
5
-
pF
-
5
-
pF
-
16
-
pF
-1.0
-0.0004
-
µA
-
0.003
1.0
µA
-1.0
-0.0004
-
µA
-15
-
15
V
-
150
175
Ω
-
0.01
5.0
nA
-5.0
-0.02
-
nA
-
0.01
5.0
nA
-5.0
-0.02
-
nA
-
0.1
5.0
nA
-5.0
-0.15
-
nA
3
FN3118.4
December 21, 2005