5962-0721301QHC Datasheet, PDF (3/6 Pages) Intersil Corporation – 500MHz Rail-to-Rail Amplifiers

5962-0721301QHC, 5962-0721302QHC, 5962-0721302QDC
Absolute Maximum Ratings (T_A = 25°C)
Supply Voltage from V_S+ to V_S- . . . . . . . . . . . . . . . . . . . . . . . . 5.5V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . V_S+ +0.3V to V_S- -0.3V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2V
Continuous Output Current . . . . . . . . . . . . . . . . . . . 20mA / Op Amp
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . 74.3mW / Op Amp
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
Ambient Operating Temperature . . . . . . . . . . . . . . .-55°C to +125°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +150°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are
at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications V_S+ = 5V, V_S- = GND, T_A = 25°C, V_CM = 2.5V, R_L to 2.5V, A_V = 1, Unless Otherwise Specified
PARAMETER
DESCRIPTION
CONDITIONS
MIN TYP MAX UNIT
INPUT CHARACTERISTICS
R_IN
Input Resistance
C_IN
Input Capacitance
OUTPUT CHARACTERISTICS
Common Mode
3.5
MΩ
0.5
pF
R_OUT
Output Resistance
I_OUT
Linear Output Current
ENABLE (5962-0721301QHC ONLY)
A_V = +1
30
mΩ
65
mA
t_EN
Enable Time
t_DS
Disable Time
V_IH-ENB
ENABLE Pin Voltage for Power-up
V_IL-ENB
ENABLE Pin Voltage for Shut-down
AC PERFORMANCE
200
ns
25
ns
0.8
V
2
V
BW
-3dB Bandwidth
BW
Peak
GBWP
±0.1dB Bandwidth
Peaking
Gain Bandwidth Product
A_V = +1, R_F = 0Ω, C_L = 2.5pF
A_V = -1, R_F = 1kΩ, C_L = 2.5pF
A_V = +2, R_F = 1kΩ, C_L = 2.5pF
A_V = +10, R_F = 1kΩ, C_L = 2.5pF
A_V = +1, R_F = 0Ω, C_L = 2.5pF
A_V = +1, R_L = 1kΩ, C_L = 2.5pF
500
MHz
140
MHz
165
MHz
18
MHz
35
MHz
2
dB
200
MHz
PM
Phase Margin
SR
Slew Rate
t_R
Rise Time
t_F
Fall Time
OS
Overshoot
R_L = 1kΩ, C_L = 2.5pF
A_V = 2, R_L = 100Ω, V_OUT = 0.5V to 4.5V
2.5V_STEP, 20% - 80%
2.5V_STEP, 20% - 80%
200mV step
55
°
600
V/µs
4
ns
2
ns
10
%
t_PD
Propagation Delay
200mV step
t_S
0.1% Settling Time
200mV step
dG
Differential Gain
A_V = +2, R_F = 1kΩ, R_L = 150Ω
dP
Differential Phase
A_V = +2, R_F = 1kΩ, R_L = 150Ω
e_N
Input Noise Voltage
f = 10kHz
i_N+
Positive Input Noise Current
f = 10kHz
i_N-
Negative Input Noise Current
f = 10kHz
e_S
Channel Separation
f = 100kHz
1
ns
15
ns
0.01
%
0.01
°
12
nV/√Hz
1.7
pA/√Hz
1.3
pA/√Hz
95
dB
3
FN6478.0
March 30, 2007