SP601 Datasheet, PDF (2/7 Pages) Intersil Corporation – Half Bridge 500VDC Driver

SP601
Absolute Maximum Ratings Full Temperature Range, All Thermal Information
Voltage Referenced to V_SS Unless Otherwise Noted. Note 1, Note 2.
Low Voltage Power Supply, V_BIAS (Note 1). . . . . . . . . . . . . . 18V_DC
Floating Low Voltage Boot Strap . . . . . . . . . . . . . . . . . . . . . . 18V_DC
Power Supply to Phase, V_BS
Low Voltage Signal Pins
Fault, I_TRIPSEL, V_DD, TRIP_L , CL1 , G2L . . . -0.5V_DC to V_DD +0.5
G1L, D1L, V_DF, TOP, BOT
CL2, TRIP_U, G1U, G2U, D1U to Phase . . . .-0.5_VDC to V_BS+0.5
High Voltage Pins
Phase, V_PHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500V_DC
(V_BS, V_OUT, TRIP_U, CL2, G2U and D1U: 0V-18V Higher Than
Phase)
Dynamic High Voltage Rating Phase,. . . . . . . . . . . . . 10,000V/µs
DV_PHASE/DT
Thermal Resistance, Junction-to-Ambient
θ_JA
Plastic DIP Package . . . . . . . . . . . . . . . . . . . . . . . . 75^oC/W
Maximum Package Power Dissipation at T_A = +85^oC, P_O
Plastic DIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500mW
Operating Ambient Temperature Range,
Storage Temperature Range, T_S . . . . . .
Lead Temperature (Soldering 10s) . . . . .
T_A.
...
...
.
.
.
.
.
.
.
.
.
.
.
.
. .-40^oC to +85^oC
.-40^oC to +150^oC
. . . . . . . . +265^oC
NOTES:
1. Care must be taken in the application of V_BIAS as not to impose high peak dissipation demands on a relatively small metallized noise dropping resistor (R_ND).
Prolonged high peak currents may result if +15V_DC is applied abruptly and/or if the local bypass capacitor C_DD is large. It is suggested that C_DD be ≤ 10MFD.
If it is desirable to switch the 15V_DC source or if a C_DD is larger, additional series impedance may be required.
2. Consult factory for additional package offerings.
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Electrical Specifications (V_BIAS = 15V, Pulsed <300ms), Unless Otherwise Noted, All Parameters Referenced to V_SS Except TRIP_U,
CL2, G1U, D1U, and V_BS Referenced to PHASE. D_F: V_DF to V_BS, C_F: V_BS to PHASE
PARAMETER
SYMBOL
TEMP
MIN
TYP
MAX UNITS
DC CHARACTERISTICS
Input Current (5V < V_TOP, V_BOT, V_TRIPSEL < 15V)
I_BIAS Quiescent Current (All Inputs Low)
I_BIAS Quiescent Current
(V_OUT ≥ V_BIAS, and All Inputs Low)
I_BS Quiescent Current Bootstrap Supply
ENABLE Threshold Level
UP/DN Threshold Level
Current Trip Select Threshold Level
Trip Lower and Upper Comparator Threshold
Level - Normal (I_TRIPSEL = V_SS)
Trip Lower and Upper Comparator Threshold
Level - Boost (I_TRIPSEL = V_DD) % of Measured
V_{TRIP L/UN}
Under Voltage Lockout Thresholds (V_DD and V_BS)
Phase Out of Status Voltage Threshold (PHASE)
Faultbar Impedance at I_FBAR = 1mA
I_IN
I_BIASL
I_BIASH
I_BS
V_TOP
V_BOT
V_TRIPSEL
V_{TRIP L/UN}
V_{TRIP L/UB}
V_LOCK
V_OSVT
RF
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
+25^oC
-40^oC to +85^oC
-
-
-
-
-
-
-
-
7
6.95
7
6.95
7
6.95
90
90
110
109
9
9.7
5
4.7
500
450
20
30
1.7
1.7
1.7
1.7
875
900
8
8
8
8
8
8
105
105
130
130
10
10.5
7
7
760
760
30
µA
33
µA
2.05
mA
2.1
mA
2.05
mA
2.1
mA
1000
µA
1060
µA
9
V
9.1
V
9
V
9.1
V
9
V
9.1
V
125
mV
127
mV
150
%
152
%
11.5
V
11.8
V
9
V
9.6
V
1000
Ω
1100
Ω
2