ISL59885_07 Datasheet, PDF (2/13 Pages) Intersil Corporation – Auto-Adjusting Sync Separator for HD and SD Video

ISL59885
Absolute Maximum Ratings (T_A = +25°C)
V_DD Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7V
Pin Voltages . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to V_CC +0.5V
Operating Ambient Temperature Range . . . . . . . . . .-40°C to +85°C
Thermal Information
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +150°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .400mW
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
DC Electrical Specifications
PARAMETER
I_DD, Quiescent
Clamp Voltage
Clamp Discharge Current
Clamp Charge Current
V_OL Output Low Voltage
V_OH Output High Voltage
V_DD = 3.3V, T_A = +25°C, C_SET = 56nF, unless otherwise specified.
DESCRIPTION
MIN
(Note 1)
TYP
V_DD = 3.3V
Pin 2, I_LOAD = -100µA
Pin 2 = 2V
1.5
2.2
1.35
1.5
6
15
Pin 2 = 1V
-9
-7.2
I_OL = 1.6mA
I_OH = -40µA
I_OH = -1.6mA
0.24
3
3.2
2.5
3.0
MAX
(Note 1)
4
1.65
30
-5.2
0.5
UNIT
mA
V
µA
mA
V
V
V
Dynamic Characteristics
PARAMETER
DESCRIPTION
MIN
MAX
(Note 1)
TYP
(Note 1)
Comp Sync Prop Delay, t_CS
Horizontal Sync Delay, t_HS
Horizontal Sync Width, t_HS-PW
Vertical Sync Width, t_VS
(See Figure 9)
(See Figure 9)
(See Figure 9)
Normal or default trigger, 50% to 50%
(see Figure 7)
35
75
40
80
3.8
5.2
6.2
230
280
350
Vertical Sync Default Delay, t_VSD
Input Dynamic Range
Slice Level
HD Pin Level
(See Figure 10)
28
50
68
Video input amplitude to maintain slice level
0.5
2
spec, V_DD = 3.3V
V_SLICE above V_CLAMP
50
70
90
720p, 1080i, 1080p
0
NOTE:
1. Parts are 100% tested at +25°C. Over-temperature limits established by characterization and are not production tested.
UNIT
ns
ns
µs
µs
µs
V_P-P
mV
V
2
FN7442.6
August 15, 2007