ISL55012_14 Datasheet, PDF (2/6 Pages) Intersil Corporation – MMIC Silicon Bipolar Broadband Amplifier

ISL55012
Absolute Maximum Ratings (T_A = +25°C)
Supply Voltage from VSP to GND . . . . . . . . . . . . . . . . . . . . . . . . 6V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . V_S+ +0.3V to GND -0.3V
Ambient Operating Temperature . . . . . . . . . . . . . . . .-40°C to +85°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +125°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +135°C
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7) . . .6000V
Machine Model (Per EIAJ ED-4701 Method C-111) . . . . . . . .300V
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +125°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . . +135°C
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (°C/W)
6 Ld SC-70 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
200
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty..
1. θ_JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only.
Electrical Specifications V_SP = +5V, Z_RSC = Z_LOAD = 50Ω, T_A = +25°C, 24Ω V_SP to OUT, unless otherwise specified.
PARAMETER
DESCRIPTION
CONDITIONS
MIN TYP MAX
Vsp
Supply Voltage
To operate below 5V, the 24Ω resistor to supply 3.0
5.5
should be reduced
Gt
Small Signal Gain
1.0GHz
17
18.3 19.5
1.5GHz
16.1 17.4 18.6
2.0GHz
15.1 16.6 17.6
P1dB
Output Power at 1dB Compression 1.0GHz
16
17.7
19
2.0GHz
15.9 17.2 18.9
OIP3
Output Third Order Intercept Point
1.0GHz
30
2.0GHz
27
OIP2
Output Second Order Intercept Point Input tones at 1.0GHz and 1.1GHz,
44.2
at Input Power = -15dBm, Output tone 2.1GHz
BW
3dB Bandwidth
3dB below Gain @ 500MHz
2.4
IRL
Input Return Loss
1.0GHz Z_RSC = 75Ω, Z_LOAD = 50Ω
23.5
ORL
Output Return Loss
1.0GHz Z_RSC = 75Ω, Z_LOAD = 50Ω
21.8
RISOL
Reverse Isolation
2.0GHz
22.4
NF
Noise Figure
2.0GHz
4.7
ID
Device Operating Current
56
63.5
71
UNIT
V
dB
dB
dB
dBm
dBm
dBm
dBm
dBm
GHz
dB
dB
dB
dB
mA
2
FN6258.2
August 25, 2010