ISL28166_08 Datasheet, PDF (2/13 Pages) Intersil Corporation – 39μA Micropower Single and Dual Rail-to-Rail Input-Output Low Input Bias Current (RRIO) Op Amps

ISL28166, ISL28266
Absolute Maximum Ratings (T_A = +25°C)
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5V
Supply Turn-on Voltage Slew Rate . . . . . . . . . . . . . . . . . . . . . 1V/µs
Differential Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . V- - 0.5V to V+ + 0.5V
ESD Rating
Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3kV
Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .300V
Thermal Information
Thermal Resistance (Typical Note 1)
θ_JA (°C/W)
6 Ld SOT-23 Package . . . . . . . . . . . . . . . . . . . . . . .
230
8 Ld MSOP Package . . . . . . . . . . . . . . . . . . . . . . . .
160
8 Ld SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . .
115
Output Short-Circuit Duration . . . . . . . . . . . . . . . . . . . . . . .Indefinite
Ambient Operating Temperature Range . . . . . . . . .-40°C to +125°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . +125°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
1. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications V₊ = 5V, V_- = 0V,V_CM = 2.5V, T_A = +25°C unless otherwise specified. Boldface limits apply over the operating
temperature range, -40°C to +125°C. Temperature data established by characterization.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
MAX
(Note 2) TYP (Note 2) UNIT
V_OS
-^Δ----^V----^O----^S--
ΔT
I_OS
Input Offset Voltage
Input Offset Drive vs Temperature
Input Offset Current
6 Ld SOT-23
-600
-7
-600
1.5
-1.5
0.34
-5
600
µV
600
µV/°C
1.2
nA
2.5
I_B
Input Bias Current
-2
1.14
5
nA
-3.5
5
E_N
I_N
CMIR
Input Noise Voltage Density
Input Noise Current Density
Input Common-Mode Voltage Range
F_O = 1kHz
F_O = 1kHz
46
nV/√Hz
0.14
pA/√Hz
0
5
V
CMRR
Common-Mode Rejection Ratio
V_CM = 0V to 5V
80
110
dB
75
PSRR
Power Supply Rejection Ratio
V_S = 2.4V to 5V
90
104
dB
75
A_VOL
Large Signal Voltage Gain
V_O = 0.5V to 4.5V, R_L = 100kΩ
200
412
175
V/mV
V_O = 0.5V to 4.5V, R_L = 1kΩ
35
70
30
V/mV
V_OUT
Maximum Output Voltage Swing
Output low, R_L = 100kΩ
3
6
mV
8
Output low, R_L = 1kΩ
130
150
mV
200
Output high, R_L = 100kΩ
4.992 4.995
V
4.99
Output high, R_L = 1kΩ
4.85 4.88
V
4.8
SR
Slew Rate
0.05
V/µs
GBW
I_S,ON
Gain Bandwidth Product
Supply Current, Enabled
A_V = 1
250
kHz
29
39
47
µA
18
56
I_S,OFF
Supply Current, Disabled
10
14
µA
16
2
FN6155.3
March 20, 2008