ISL28146_0806 Datasheet, PDF (2/16 Pages) Intersil Corporation – 5MHz, Single and Dual Rail-to-Rail Input-Output (RRIO) Op Amps

ISL28146, ISL28246
Absolute Maximum Ratings (T_A = +25°C)
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.75V
Supply Turn On Voltage Slew Rate . . . . . . . . . . . . . . . . . . . . . 1V/µs
Differential Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5mA
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . V- - 0.5V to V+ + 0.5V
ESD Rating
Human Body Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3kV
Machine Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .300V
Charged Device Model. . . . . . . . . . . . . . . . . . . . . . . . . . . . .1500V
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (°C/W)
6 Ld SOT-23 Package . . . . . . . . . . . . . . . . . . . . . . .
230
8 Ld SOIC Package . . . . . . . . . . . . . . . . . . . . . . . .
120
8 Ld MSOP Package . . . . . . . . . . . . . . . . . . . . . . . .
160
Output Short-Circuit Duration . . . . . . . . . . . . . . . . . . . . . . .Indefinite
Ambient Operating Temperature Range . . . . . . . . .-40°C to +125°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . . . . . . . . +125°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
1. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications
V₊ = 5V, V_- = 0V, V_CM = 2.5V, R_L = Open, T_A = +25°C unless otherwise specified.
Boldface limits apply over the operating temperature range, -40°C to +125°C.
Temperature data established by characterization.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
MAX
(Note 2) TYP (Note 2) UNIT
DC SPECIFICATIONS
V_OS
-^Δ----^V----^O----^S--
ΔT
I_OS
Input Offset Voltage
Input Offset Voltage vs Temperature
Input Offset Current
-650
30
650
µV
-750
750
0.3
µV/°C
-10
0
10
nA
-15
15
I_B
Input Bias Current
-35
16
35
nA
-40
40
CMIR
Common-Mode Voltage Range
Guaranteed by CMRR
0
5
V
CMRR
Common-Mode Rejection Ratio
V_CM = 0V to 5V
90
114
dB
85
PSRR
Power Supply Rejection Ratio
V₊ = 2.4V to 5.5V
90
99
dB
85
A_VOL
Large Signal Voltage Gain
V_O = 0.5V to 4V, R_L = 100kΩ to V_CM
600 1770
500
V/mV
V_OUT
Maximum Output Voltage Swing
V_O = 0.5V to 4V, R_L = 1kΩ to V_CM
Output low, R_L = 100kΩ to V_CM
140
V/mV
3
6
mV
10
Output low, R_L = 1kΩ to V_CM
70
90
mV
110
Output high, R_L = 100kΩ to V_CM
4.99 4.994
mV
4.98
Output high, R_L = 1kΩ to V_CM
4.92 4.94
V
4.89
I_S,ON
Supply Current, Enabled
Per Amplifier
1
1.25
mA
1.4
I_S,OFF
Supply Current, Disabled
10
14
µA
16
2
FN6321.3
June 23, 2008