ICL8038 Datasheet, PDF (2/10 Pages) Intersil Corporation – Precision Waveform Generator/Voltage Controlled Oscillator

ICL8038
Absolute Maximum Ratings
Supply Voltage (V- to V+). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36V
Input Voltage (Any Pin) . . . . . . . . . . . . . . . . . . . . . . . . . . . . V- to V+
Input Current (Pins 4 and 5). . . . . . . . . . . . . . . . . . . . . . . . . . . 25mA
Output Sink Current (Pins 3 and 9) . . . . . . . . . . . . . . . . . . . . . 25mA
Operating Conditions
Temperature Range
ICL8038AC, ICL8038BC, ICL8038CC . . . . . . . . . . . . 0^oC to 70^oC
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W) θ_JC (^oC/W)
CERDIP Package. . . . . . . . . . . . . . . . .
75
20
PDIP Package . . . . . . . . . . . . . . . . . . . 115
N/A
Maximum Junction Temperature (Ceramic Package) . . . . . . . .175^oC
Maximum Junction Temperature (Plastic Package) . . . . . . . .150^oC
Maximum Storage Temperature Range . . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300^oC
Die Characteristics
Back Side Potential . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V-
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications
PARAMETER
V_SUPPLY = ±10V or +20V, T_A = 25^oC, R_L = 10kΩ, Test Circuit Unless Otherwise Specified
SYMBOL
TEST
CONDITIONS
ICL8038CC
ICL8038BC
ICL8038AC
MIN TYP MAX MIN TYP MAX MIN TYP MAX
UNITS
Supply Voltage Operating Range V_SUPPLY
V+
Single Supply
+10 - +30 +10 - +30 +10 - +30
V
V+, V- Dual Supplies
±5 - ±15 ±5 - ±15 ±5 - ±15
V
Supply Current
I_SUPPLY V_SUPPLY = ±10V
(Note 2)
12 20 - 12 20 - 12 20
mA
FREQUENCY CHARACTERISTICS (All Waveforms)
Max. Frequency of Oscillation
Sweep Frequency of FM Input
Sweep FM Range
f_MAX
f_SWEEP
(Note 3)
100 -
- 100 -
- 100 -
-
kHz
- 10 -
- 10 -
- 10 -
kHz
- 35:1 -
- 35:1 -
- 35:1 -
FM Linearity
Frequency Drift with
Temperature (Note 5)
Frequency Drift with Supply Voltage
∆f/∆T
∆f/∆V
10:1 Ratio
0^oC to 70^oC
Over Supply
Voltage Range
- 0.5 -
- 250 -
- 0.05 -
- 0.2 -
- 180 -
- 0.05
- 0.2 -
- 120
- 0.05 -
%
ppm/^oC
%/V
OUTPUT CHARACTERISTICS
Square Wave
Leakage Current
Saturation Voltage
Rise Time
Fall Time
Typical Duty Cycle Adjust
(Note 6)
I_OLK
V_SAT
t_R
t_F
∆D
V₉ = 30V
I_SINK = 2mA
R_L = 4.7kΩ
R_L = 4.7kΩ
-
-
1
-
-
1
-
-
1
µA
- 0.2 0.5 - 0.2 0.4 - 0.2 0.4
V
- 180 -
- 180 -
- 180 -
ns
- 40 -
- 40 -
- 40 -
ns
2
98 2 - 98 2 - 98
%
Triangle/Sawtooth/Ramp
Amplitude
Linearity
V_TRIAN- R_TRI = 100kΩ
GLE
-
0.30 0.33 - 0.30 0.33 - 0.30 0.33 -
xV_SUPPLY
- 0.1 -
- 0.05 -
- 0.05 -
%
Output Impedance
Z_OUT I_OUT = 5mA
- 200 -
- 200 -
- 200 -
Ω
2