ICL7621 Datasheet, PDF (2/9 Pages) Intersil Corporation – Dual, Low Power CMOS Operational Amplifiers

ICL7621
Absolute Maximum Ratings
Supply Voltage V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . V- -0.3 to V+ +0.3V
Differential Input Voltage (Note 3) . . . . . . . . . [(V+ +0.3) - (V- -0.3)]V
Duration of Output Short Circuit (Note 4). . . . . . . . . . . . . . Unlimited
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to +70°C
Thermal Information
Thermal Resistance (Typical, Note 5)
θ_JA (°C/W) θ_JC (°C/W)
PDIP Package . . . . . . . . . . . . . . . . . . . 120
N/A
SOIC Package . . . . . . . . . . . . . . . . . . . 160
N/A
Maximum Junction Temperature (Plastic Package) . . . . . . . +150°C
Maximum Storage Temperature Range . . . . . . . . . . -65°C to +150°C
Pb-Free Reflow Profile. . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
*Pb-free PDIPs can be used for through hole wave solder
processing only. They are not intended for use in Reflow solder
processing applications.
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTES:
3. Long term offset voltage stability will be degraded if large input differential voltages are applied for long periods of time.
4. The outputs may be shorted to ground or to either supply, for V_SUPPLY ≤10V. Care must be taken to insure that the dissipation rating is not
exceeded.
5. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications V_SUPPLY = ±5V, Unless Otherwise Specified.
PARAMETER
Input Offset Voltage
SYMBOL
V_OS
TEST CONDITIONS
R_S ≤ 100kΩ
Temperature Coefficient of V_OS
Input Offset Current
ΔV_OS/ΔT
I_OS
R_S ≤ 100kΩ
TEMP.
(°C)
+25
Full
-
+25
0 to +70
MIN
MAX
(Note 6) TYP (Note 6) UNITS
-
-
15
mV
-
-
20
mV
-
25
-
µV/^oC
-
0.5 30
pA
-
-
300
pA
-55 to +125 -
800
pA
Input Bias Current
I_BIAS
+25
0 to +70
-
1.0 50
pA
-
-
400
pA
Common Mode Voltage Range
Output Voltage Swing
Large Signal Voltage Gain
-55 to +125 -
- 4000 pA
V_CMR
V_OUT
I_Q = 100µA
I_Q = 100µA, R_L = 100kΩ
+25
±4.2 -
-
V
+25
±4.9 -
-
V
0 to +70 ±4.8 -
-
V
-55 to +125 ±4.5 -
-
V
A_VOL
V_O = ±4.0V, R_L = 100kΩ, I_Q = 100µA
+25
80 102
-
dB
0 to +70
75
-
-
dB
-55 to +125 68
-
-
dB
Unity Gain Bandwidth
Input Resistance
Common Mode Rejection Ratio
Power Supply Rejection Ratio
(V_SUPPLY = ±8V to ±2V)
Input Referred Noise Voltage
Input Referred Noise Current
Supply Current (Per Amplifier)
Channel Separation
GBW
R_IN
CMRR
PSRR
I_Q = 100µA
R_S ≤ 100kΩ , I_Q = 100µA
R_S ≤ 100kΩ , I_Q = 100µA
e_N
i_N
I_SUPPLY
V_O1/V_O2
R_S = 100Ω, f = 1kHz
R_S = 100Ω, f = 1kHz
No Signal, No Load, I_Q = 100µA
A_V = 100
+25
- 0.48 -
MHz
+25
-
10¹²
-
Ω
+25
70
91
-
dB
+25
80
86
-
dB
+25
-
100
- nV/√Hz
+25
- 0.01 - pA/√Hz
+25
-
0.1 0.25 mA
+25
-
120
-
dB
2
FN3403.5
March 4, 2010