HFA1106 Datasheet, PDF (2/16 Pages) Intersil Corporation – 315MHz, Low Power, Video Operational Amplifier with Compensation Pin

HFA1106
Absolute Maximum Ratings
Voltage Between V+ and V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11V
DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_SUPPLY
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8V
Output Current (Note 1) . . . . . . . . . . . . . . . . Short Circuit Protected
30mA Continuous
60mA ≤ 50% Duty Cycle
ESD Rating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >600V
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . -40^oC to 85^oC
Thermal Information
Thermal Resistance (Typical, Note 2)
θ_JA (^oC/W)
PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130
SOIC Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 170
Maximum Junction Temperature (Die Only) . . . . . . . . . . . . . . . 175^oC
Maximum Junction Temperature (Plastic Package) . . . . . . . . 150^oC
Maximum Storage Temperature Range . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s). . . . . . . . . . . . 300^oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Output is short circuit protected to ground. Brief short circuits to ground will not degrade reliability; however, continuous (100% duty cycle)
output current must not exceed 30mA for maximum reliability.
2. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications V_SUPPLY = ±5V, A_V = +1, R_F = 510Ω, C_COMP = 0pF, R_L = 100Ω , Unless Otherwise Specified
PARAMETER
(NOTE 3)
TEMP.
TEST CONDITIONS TEST LEVEL (^oC)
MIN
TYP
MAX UNITS
INPUT CHARACTERISTICS
Input Offset Voltage
A
25
-
2
5
mV
Average Input Offset Voltage Drift
A
Full
-
3
8
mV
B
Full
-
1
10
µV/^oC
Input Offset Voltage Common-Mode
Rejection Ratio
Input Offset Voltage Power Supply
Rejection Ratio
Non-Inverting Input Bias Current
∆V_CM = ±1.8V
∆V_CM = ±1.8V
∆V_CM = ±1.2V
∆V_PS = ±1.8V
∆V_PS = ±1.8V
∆V_PS = ±1.2V
A
25
47
50
-
dB
A
85
45
48
-
dB
A
-40
45
48
-
dB
A
25
50
54
-
dB
A
85
47
50
-
dB
A
-40
47
50
-
dB
A
25
-
6
15
µA
Non-Inverting Input Bias Current Drift
A
Full
-
10
25
µA
B
Full
-
5
60
nA / ^oC
Non-Inverting Input Bias Current
Power Supply Sensitivity
Non-Inverting Input Resistance
Inverting Input Bias Current
∆V_PS = ±1.8V
∆V_PS = ±1.8V
∆V_PS = ±1.2V
∆V_CM = ±1.8V
∆V_CM = ±1.8V
∆V_CM = ±1.2V
A
25
-
0.5
1
µA/V
A
85
-
0.8
3
µA/V
A
-40
-
0.8
3
µA/V
A
25
0.8
1.2
-
MΩ
A
85
0.5
0.8
-
MΩ
A
-40
0.5
0.8
-
MΩ
A
25
-
2
7.5
µA
Inverting Input Bias Current Drift
A
Full
-
5
15
µA
B
Full
-
60
200
nA / ^oC
Inverting Input Bias Current
Common-Mode Sensitivity
Inverting Input Bias Current Power
Supply Sensitivity
∆V_CM = ±1.8V
∆V_CM = ±1.8V
∆V_CM = ±1.2V
∆V_PS = ±1.8V
∆V_PS = ±1.8V
∆V_PS = ±1.2V
A
25
-
3
6
µA / V
A
85
-
4
8
µA / V
A
-40
-
4
8
µA / V
A
25
-
2
5
µA / V
A
85
-
4
8
µA / V
A
-40
-
4
8
µA / V
3-29