HC5503T_04 Datasheet, PDF (2/6 Pages) Intersil Corporation – Balanced PBX / Key System SLIC, Subscriber Line Interface Circuit

HC5503T
Absolute Maximum Ratings (Note 1)
Maximum Continuous Supply Voltages
(V_BAT) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -60 to 0.5V
(V_CC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 7V
(V_CC - V_BAT) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .75V
Relay Drive Voltage (V_RD). . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 15V
Operating Conditions
Temperature Range
HC-5503T-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 75°C
Positive Supply Voltage (V_CC). . . . . . . . . . . . . . . . . . 4.75V to 5.25V
Negative Supply Voltage (V_BAT) . . . . . . . . . . . . . . . . . . -24V to -58V
High Level Logic Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . 2.4V
Low Level Logic Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . 0.6V
Thermal Information
Thermal Resistance (Typical, Note 2)
θ_JA (°C/W)
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . .
75
Maximum Junction Temperature (Plastic Package) . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . -65°C to 150°C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300°C
(SOIC - Lead Tips Only)
Die Characteristics
Transistor Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
Diode Count. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
Die Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 137 x 102
Substrate Potential . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connected
Process . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Bipolar-DI
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Functional
operability under any of these conditions is not necessarily implied.
2. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications Unless Otherwise Specified, V_BAT = -48V, V_CC = 5V, AG = BG = DG = 0V, Typical Parameters
T_A = 25°C. Min-Max Parameters are Over Operating Temperature Range
PARAMETER
CONDITIONS
MIN
TYP MAX
Off Hook I_B+
Off Hook I_B-
Off Hook Loop Current
Off Hook Loop Current
Off Hook Loop Current
Switch Hook Detection Threshold
Dial Pulse Distortion
R_L = 600Ω, T_A = 25°C
R_L = 600Ω
R_L = 1200Ω
R_L = 1200Ω, V_BAT = -42V, T_A = 25°C
R_L = 200Ω
SHD = V_OL
SHD = V_OH
-
-
5.3
-
-
39
-
21
-
17.5
-
-
25.5
30
34.5
10
-
-
-
-
5
0
-
5
Longitudinal Balance
2-Wire Off Hook
1V_RMS 200Hz - 3400Hz, (Note 3) IEEE Method
0°C ≤ T_A ≤ 75°C
-
65
-
2-Wire On Hook
-
63
-
Tip and Ring to TX, Off Hook
-
58
-
Insertion Loss
2-Wire to TX, RX to 2-Wire
At 1kHz, 0dBm Input Level, Referenced 600Ω
-
±0.05 ±0.2
Frequency Response
200 - 3400Hz Referenced to Absolute Loss at 1kHz and
-
0dBm Signal Level (Note 3)
±0.02 ±0.05
Idle Channel Noise
2-Wire to TX, RX to 2-Wire
(Note 3)
-
1
5
-
-89
-85
Trans Hybrid Loss,
RX to TX
Balance Network Set Up for 600Ω Termination at 1kHz
-
40
-
Overload Level, 2-Wire to TX, RX to 2-Wire V_CC = +5V, (Note 3)
2.5
-
-
UNITS
mA
mA
mA
mA
mA
mA
mA
µs
dB
dB
dB
dB
dB
dBrnC
dBm0p
dB
V_PEAK
2