HC5503PRI Datasheet, PDF (2/8 Pages) Intersil Corporation – Low Cost SLIC For Large Telecom Switches

HC5503PRI
Absolute Maximum Ratings
Maximum Continuous Supply Voltages
(V_B-) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -60 to 0.5V
(V_B+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 7V
(V_B+ - V_B-) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .75V
Relay Drive Voltage (V_RD) . . . . . . . . . . . . . . . . . . . . . . . . -0.5 to 15V
Operating Conditions
Operating Temperature Range . . . . . . . . . . . . . . . . . .-40°C to 85°C
Relay Driver Voltage (V_RD) . . . . . . . . . . . . . . . . . . . . . . . . 5V to 12V
Positive Supply Voltage (V_B+) . . . . . . . . . . . . . . . . . . 4.75V to 5.25V
Negative Supply Voltage (V_B-). . . . . . . . . . . . . . . . . . . . -40V to -58V
High Level Logic Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . 2.4V
Low Level Logic Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . 0.6V
Subscriber Loop Resistance . . . . . . . . . . . . . . . . . . . 200Ω - 1800Ω
Thermal Information
Thermal Resistance (Typical, Note 2
θ_JA (°C/W)
24 Lead SOIC . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
75
Maximum Junction Temperature Plastic . . . . . . . . . . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . . -65°C to 150°C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300°C
(SOIC - Lead Tips Only)
Die Characteristics
Transistor Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 185
Diode Count. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
Die Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 137 x 102
Substrate Potential . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connected
Process . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Bipolar-DI
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Functional
operability under any of these conditions is not necessarily implied.
2. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications Unless Otherwise Specified, V_B- = -48V, V_B+ = 5V, AG = BG = DG = 0V, R_P = 50Ω, R_S = 100Ω, Typical
Parameters. T_A = 25°C. Min-Max Parameters are Over Operating Temperature Range
PARAMETER
CONDITIONS
MIN
TYP MAX UNITS
On Hook Power Dissipation
Off Hook Power Dissipation
On Hook I_B+
Off Hook I_B+
On Hook I_B-
Off Hook I_B-
Off Hook Loop Current
Off Hook Loop Current
Fault Currents
TIP to Ground
I_LONG = 0 (Notes 3,4)
R_L = 600Ω, I_LONG = 0 (Notes 3, 4)
R_L = ∞, I_LONG = 0
R_L = 600Ω, I_LONG = 0
R_L = ∞, I_LONG = 0
R_L = 600Ω, I_LONG = 0
R_L = 1800Ω (I_LOOP = 0)
R_L = 200Ω, I_LONG = 0 (Note 3)
-
113
-
mW
-
750
-
mW
-
1.4
-
mA
-
2.8
-
mA
-
2.2
-
mA
-
31
-
mA
18
-
-
mA
25
30
35
mA
-
27
-
mA
RING to Ground
-
55
-
mA
TIP to RING
-
30
-
mA
TIP and RING to Ground
-
69
-
mA
Ring Relay Drive V_OL
Ring Relay Driver Off Leakage
DC Ring Trip Threshold
I_OL = 62mA
V_RD = 12V, RC = 1 = HIGH, T_A = 25°C
-
0.2
0.5
V
-
-
100
µA
6.5
10
13.5
mA
Switch Hook Detection Threshold
5.0
7.5
10
mA
Loop Current During Power Denial
Dial Pulse Distortion
R_L = 200Ω
(Note 4)
-
3.2
-
mA
0
-
0.5
ms
Receive Input Impedance
(Note 4)
-
110
-
kΩ
Transmit Output Impedance
(Note 4)
-
10
20
Ω
2
FN6101.0