ISL28107_10 Datasheet, PDF (16/23 Pages) Intersil Corporation – Precision Single and Dual Low Noise Operational Amplifiers

ISL28107, ISL28207
where:
• T_MAX = Maximum ambient temperature
• θ_JA = Thermal resistance of the package
• PD_MAX = Maximum power dissipation of 1 amplifier
• V_S = Total supply voltage
• I_qMAX = Maximum quiescent supply current of 1
amplifier
• V_OUTMAX = Maximum output voltage swing of the
application
• R_L = Load resistance
ISL28107, ISL28207 SPICE Model
Figure 54 shows the SPICE model schematic and
Figure 55 shows the net list for the ISL28107, ISL28207
SPICE model. The model is a simplified version of the
actual device and simulates important AC and DC
parameters. AC parameters incorporated into the model
are: 1/f and flatband noise, Slew Rate, CMRR, Gain and
Phase. The DC parameters are VOS, IOS, total supply
current and output voltage swing. The model uses
typical parameters given in the “Electrical
Specifications” Table beginning on page 3. The AVOL is
adjusted for 155dB with the dominate pole at 0.01Hz.
The CMRR is set (145dB, f_cm = 100Hz). The input stage
models the actual device to present an accurate AC
representation. The model is configured for ambient
temperature of +25°C.
Figures 56 through 66 show the characterization vs
simulation results for the Noise Voltage, Closed Loop
Gain vs Frequency, Closed Loop Gain vs RL, Large Signal
Step Response, Open Loop Gain Phase and Simulated
CMRR vs Frequency.
LICENSE STATEMENT
The information in this SPICE model is protected under
the United States copyright laws. Intersil Corporation
hereby grants users of this macro-model hereto referred
to as “Licensee”, a nonexclusive, nontransferable licence
to use this model as long as the Licensee abides by the
terms of this agreement. Before using this macro-model,
the Licensee should read this license. If the Licensee
does not accept these terms, permission to use the
model is not granted.
The Licensee may not sell, loan, rent, or license the
macro-model, in whole, in part, or in modified form, to
anyone outside the Licensee’s company. The Licensee
may modify the macro-model to suit his/her specific
applications, and the Licensee may make copies of this
macro-model for use within their company only.
This macro-model is provided “AS IS, WHERE IS, AND
WITH NO WARRANTY OF ANY KIND EITHER EXPRESSED
OR IMPLIED, INCLUDING BUY NOT LIMITED TO ANY
IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE.”
In no event will Intersil be liable for special, collateral,
incidental, or consequential damages in connection with
or arising out of the use of this macro-model. Intersil
reserves the right to make changes to the product and
the macro-model without prior notice.
16
FN6631.2
April 8, 2010