ISL6845_15 Datasheet, PDF (14/14 Pages) Intersil Corporation – Improved Industry Standard Single-Ended Current Mode PWM Controller

ISL6840, ISL6841, ISL6842, ISL6843, ISL6844, ISL6845
Package Outline Drawing
L8.2x3
8 LEAD DUAL FLAT NO-LEAD PLASTIC PACKAGE
Rev 2, 3/15
2.00
A
PIN 1
INDEX AREA
B
6
1
PIN #1
INDEX AREA
2X 1.50
6X 0.50
1.80 +0.10/-0.15
(4X) 0.15
TOP VIEW
(1.65)
(1.50)
(8X 0.60)
(2.80)(1.80)
(6X 0.50)
(8X 0.25)
TYPICAL RECOMMENDED LAND PATTERN
14
8X 0.40 ±0.10
8
1.65 +0.10/-0.15
BOTTOM VIEW
8X 0.25 +0.07/-0.05 ⁴
0.10 M C A B
0.90 ±0.10
0.05 MAX
SIDE VIEW
SEE DETAIL "X"
0.10 C
BASE PLANE ^C
SEATING PLANE
0.08 C
0.20 REF
C
0.05 MAX
DETAIL "X"
NOTES:
1. Dimensions are in millimeters.
Dimensions in ( ) for Reference Only.
2. Dimensioning and tolerancing conform to ASME Y14.5m-1994.
3. Unless otherwise specified, tolerance : Decimal ± 0.05
4. Dimension applies to the metallized terminal and is measured
between 0.25mm and 0.30mm from the terminal tip.
5. Tiebar shown (if present) is a non-functional feature and may be
located on any of the 4 sides (or ends).
6. The configuration of the pin #1 identifier is optional, but must be
located within the zone indicated. The pin #1 identifier may be
either a mold or mark feature.
7. Compies to JEDEC MO-229 VCED-2.
FN9124.12
September 29, 2015