ISL2111_14 Datasheet, PDF (11/13 Pages) Intersil Corporation – 100V, 3A/4A Peak, High Frequency Half-Bridge Drivers

ISL2110, ISL2111
Package Outline Drawing
L12.4x4A
12 LEAD DUAL FLAT NO-LEAD PLASTIC PACKAGE
Rev 1, 3/11
A
4.00
B
PIN #1 INDEX AREA
6
1
6
PIN 1
INDEX AREA
4.00
3.2 REF
10X 0.50 BSC
6
12X 0 . 45
1.58
( 3.80)
TOP VIEW
( 2.80 )
0.15 (4X)
( 12 X 0.65 )
( 1.58)
12
1.00 MAX
2.80
BOTTOM VIEW
SIDE VIEW
7
0.10 M C A B
0.05 M C
4 12 X 0.25
SEE DETAIL "X"
0.10 C
BASE PLANE ^C
SEATING PLANE
0.08 C
0 . 2 REF
C
( 10X 0 . 5 )
( 12X 0 . 25)
TYPICAL RECOMMENDED LAND PATTERN
0 . 00 MIN.
0 . 05 MAX.
DETAIL "X"
NOTES:
1. Dimensions are in millimeters.
Dimensions in ( ) for Reference Only.
2. Dimensioning and tolerancing conform to AMSE Y14.5m-1994.
3. Unless otherwise specified, tolerance : Decimal ± 0.05
4. Lead width applies to the metallized terminal and is measured
between 0.15mm and 0.30mm from the terminal tip.
5. Tiebar shown (if present) is a non-functional feature.
6. The configuration of the pin #1 identifier is optional, but must be
located within the zone indicated. The pin #1 identifier may be
either a mold or mark feature.
11
FN6295.6
March 8, 2012