ZL8101_14 Datasheet, PDF (1/36 Pages) Intersil Corporation – Adaptive Digital DC/DC PWM Controller with Auto Compensation

Adaptive Digital DC/DC PWM Controller with Auto
Compensation
ZL8101
The ZL8101 is a digital PWM controller with auto
compensation that is designed to work with either the ZL1505
MOSFET driver IC, ISL6611 Phase Doubler IC, or DrMOS type
devices. Current sharing allows multiple devices to be
connected in parallel to source loads with very high current
demands. Adaptive performance optimization algorithms
improve power conversion efficiency across the entire load
range. Zilker Labs Digital-DC™ technology enables a blend of
power conversion performance and power management
features.
The ZL8101 is designed to be a flexible building block for DC
power and can be easily adapted to designs ranging from a
single-phase power supply operating from a 4.5V input to a
multi-phase supply operating from a 12V input. The ZL8101
eliminates the need for complicated power supply managers
as well as numerous external discrete components.
Most operating features can be configured by simple
pin-strap/resistor selection or through the SMBus™ serial
interface. The ZL8101 uses the PMBus™ protocol for
communication with a host controller and the Digital-DC bus
for communication between other Zilker Labs devices.
Features
• Efficient Synchronous Buck Controller
• Adaptive Performance Optimization Algorithms
• ±1% Output Voltage Accuracy
• Auto Compensation
• Snapshot™ Parametric Capture
• I²C/SMBus Interface, PMBus Compatible
• Internal Non-Volatile Memory (NVM)
• Tri-State PWM Gate Outputs
• Compatible with Industry Standard DrMOS Devices
• Compatible with Intersil ISL6611 Phase Doubler
• Synchronized External Driver Control
Applications
• Servers/Storage Equipment
• Telecom/Datacom Equipment
• Power Supplies (Memory, DSP, ASIC, FPGA)
Related Literature
• AN2033 “Zilker Labs PMBus Command Set - DDC Products”
• AN2034 “Configuring Current Sharing on the ZL2004 and
ZL2006”
• AN2010 “Thermal and Layout Guidelines for Digital-DC™
Products”
96
V_OUT = 3.3V
91
V_OUT = 1.5V
86
V_OUT = 1.0V
V_OUT = 1.8V
V_OUT = 1.2V
V_OUT = 2.5V
V_IN = 12V
81
f_SW = 400kHz
L = 0.45µH
G_H = 1 x BSC050NE2Ls
G_L = 2 x BSC010NE2LS
76
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40
OUTPUT CURRENT (A)
FIGURE 1. EFFICIENCY vs LOAD CURRENT
July 13, 2012
1
FN7832.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas Inc. 2011, 2012. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.