|
X96012 Datasheet, PDF (1/27 Pages) Intersil Corporation – Universal Sensor Conditioner with Dual Look Up Table Memory and DACs | |||
|
X96012
®
Universal Sensor Conditioner with Dual Look Up Table Memory and DACs
Data Sheet
March 10, 2005
FN8216.0
FEATURES
⢠Two Programmable Current Generators
â±3.2 mA max.
â8-bit (256 Step) Resolution
âInternally Programmable full scale Current
Outputs
âExternal Resistor Pin to set full scale Current
Outputs
⢠Integrated 8-bit A/D Converter
⢠Internal Voltage Reference with Output/Input
⢠Temperature Compensation
âInternal or External Sensor
â-40°C to +100°C Range
â2.2°C / step resolution
âEEPROM Look-up Tables
⢠Hot Pluggable
⢠2176-bit EEPROM
â17 Pages
â16 Bytes per Page
⢠Write Protection Circuitry
âIntersil BlockLockâ¢
âLogic Controlled Protection
â2-wire Bus with 3 Slave Address Bits
⢠3V to 5.5V, Single Supply Operation
⢠Package
â14-Lead TSSOP
APPLICATIONS
⢠PIN Diode Bias Control
⢠RF PA Bias Control
⢠Temperature Compensated Process Control
⢠Laser Diode Bias Control
BLOCK DIAGRAM
VRef
VSense
Voltage
Reference
Mux
ADC
Mux
Temperature
Sensor
SDA
SCL
WP
A2, A1, A0
2-Wire
Interface
⢠Fan Control
⢠Motor Control
⢠Sensor Signal Conditioning
⢠Data Aquisition Applications
⢠Gain vs. Temperature Control
⢠High Power Audio
⢠Open Loop Temperature Compensation
⢠Close Loop Current, Voltage, Pressure, Temper-
ature, Speed, Position Programmable Voltage
sources, electronic loads, output amplifiers, or
function generator
DESCRIPTION
The X96012 is a highly integrated bias controller which
incorporates two digitally controlled Programmable Cur-
rent Generators, temperature compensation with dedi-
cated look-up tables, and supplementary EEPROM
array. All functions of the device are controlled via a 2-
wire digital serial interface.
Two temperature compensated Programmable Cur-
rent Generators, vary the output current with tempera-
ture according to the contents of the associated
nonvolatile look-up table. The look-up table may be
programmed with arbitrary data by the user, via the 2-
wire serial port, and either an internal or external tem-
perature sensor may be used to control the output cur-
rent response.
The integrated General Purpose EEPROM is included
for product data storage.
Look-up
Table 2
Mux
R2
DAC 2
I2
Look-up
Table 1
Mux
Control
& Status
DAC 1
I1
R1
General
Purpose
Memory
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
|
▷ |