|
X96010 Datasheet, PDF (1/26 Pages) Intersil Corporation – Sensor Conditioner with Dual Look Up Table Memory and DACs | |||
|
®
Data Sheet
October 25, 2005
X96010
FN8214.1
Sensor Conditioner with Dual Look Up
Table Memory and DACs
FEATURES
⢠Two Programmable Current Generators
â±3.2 mA max.
â8-bit (256 Step) Resolution
âExternal Resistor Pins to Set Full Scale Cur-
rent Output
⢠External Sensor Input (Single Ended)
⢠Integrated 8-bit A/D Converter
⢠Internal Voltage Reference with Output/Input
⢠Temperature Compensation
⢠EEPROM Look-up Tables
⢠Hot Pluggable
⢠Write Protection Circuitry
âIntersil BlockLockâ¢
âLogic Controlled Protection
⢠2-wire Bus with 3 Slave Address Bits
⢠3V to 5.5V, Single Supply Operation
⢠Package
â14 Ld TSSOP
⢠Pb-Free Plus Anneal Available (RoHS Compliant)
APPLICATIONS
⢠PIN Diode Bias Control
⢠RF PA Bias Control
⢠Temperature Compensated Process Control
⢠Laser Diode Bias Control
⢠Fan Control
⢠Motor Control
⢠Sensor Signal Conditioning
⢠Data Aquisition Applications
⢠Gain vs. Temperature Control
⢠High Power Audio
⢠Open Loop Temperature Compensation
⢠Close Loop Current, Voltage, Pressure, Temper-
ature, Speed, Position Programmable Voltage
sources, electronic loads, output amplifiers, or
function generator
DESCRIPTION
The X96010 is a highly integrated bias controller which
incorporates two digitally controlled Programmable Cur-
rent Generators and temperature compensation with
dedicated look-up tables. All functions of the device are
controlled via a 2-wire digital serial interface.
Two temperature compensated Programmable Cur-
rent Generators, vary the output current with tempera-
ture according to the contents of the associated
nonvolatile look-up table. The look-up table may be
programmed with arbitrary data by the user via the 2-
wire serial port, and an external temperature sensor
may be used to control the output current response.
Ordering Information
PART
TEMP
PART NUMBER MARKING RANGE (°C) PACKAGE
X96010V14I
X96010V I
-40 to 100 14 Ld TSSOP
X96010V14IZ
(Note)
X96010VI Z
-40 to 100 14 Ld TSSOP
(Pb-free)
NOTE: Intersil Pb-free plus anneal products employ special Pb-free
material sets; molding compounds/die attach materials and 100% matte
tin plate termination finish, which are RoHS compliant and compatible
with both SnPb and Pb-free soldering operations. Intersil Pb-free
products are MSL classified at Pb-free peak reflow temperatures that
meet or exceed the Pb-free requirements of IPC/JEDEC J STD-020.
PIN CONFIGURATION
A0 1
A1 2
A2 3
Vcc 4
WP 5
SCL 6
SDA 7
14 I2
13 VRef
12 VSense
11 Vss
10 R2
9 R1
8 I1
TSSOP 14L
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
|
▷ |