|
X93256 Datasheet, PDF (1/9 Pages) Intersil Corporation – Dual Digitally Controlled Potentiometers | |||
|
®
Data Sheet
March 4, 2005
X93256
FN8188.0
Dual Digitally Controlled Potentiometers
(XDCPsâ¢)
FEATURES
⢠Dual solid-state potentiometers
⢠Individual Up/Down interfaces
⢠32 wiper tap points per potentiometer
âWiper position stored in nonvolatile memory
and recalled on power-up
⢠31 resistive elements per potentiometer
âTemperature compensated
âMaximum resistance tolerance of ± 25%
âTerminal voltage, 0 to VCC
⢠Low power CMOS
âVCC = 2.7 V - 5.5 V.
âActive current, 200µA typical per potentiometer
âStandby current, 4µA max per potentiometer
⢠High reliability
âEndurance 200,000 data changes per bit
âRegister data retention, 100 years
⢠RTOTAL value = 12.5kâ¦, 50kâ¦
⢠Packages
â14-lead TSSOP
BLOCK DIAGRAM
General Description
VCC (Supply Voltage)
30K
Up/Down
(U/D1 & U/D2)
Increment
(INC1 & INC2)
Device Select
(CS1 & CS2)
Control
and
Memory
VSS (Ground)
RH1
RW1
RL1
RH2
RW2
RL2
U/D1
INC1
CS1
VCC
VSS
DESCRIPTION
The Intersil X93256 is a dual digitally controlled
potentiometer (XDCP). The device consists of two
resistor arrays, wiper switches, a control section, and
nonvolatile memory. The wiper positions are controlled
by individual Up/Down interfaces.
A potentiometer is implemented by a resistor array
composed of 31 resistive elements and a wiper switching
network. The position of each wiper element is controlled
by a set of independent CS, U/D, and INC inputs. The
position of the wiper can be stored in nonvolatile memory
and then be recalled upon a subsequent power-up
operation.
Each potentiometer is connected as a three-terminal
variable resistor and can be used in a wide variety of
applications including:
â bias and gain control
â LCD Contrast Adjustment
Detailed Single Potentiometer Description
5-Bit
Up/Down
Counter
5-Bit
Nonvolatile
Memory
Store and
Control
Recall
Circuitry
31
30
29
28
One
of
Thirty
Two
Decoder
2
1
0
RH1
RW
Transfer
Resistor
Gates
Array
RL1
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
XDCP is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
|
▷ |