MS82C55A_06 Datasheet, PDF (1/26 Pages) Intersil Corporation – CMOS Programmable Peripheral Interface

®
Data Sheet
MS82C55A, MQ82C55A, MP82C55A
June 15, 2006
FN6140.2
CMOS Programmable Peripheral Interface
The Intersil 82C55A is a high performance CMOS version of
the industry standard 8255A and is manufactured using a
self-aligned silicon gate CMOS process (Scaled SAJI IV).
The MX82C55A has identical features as the X82C55 with
the exception of no bus hold devices on the port pins. It is a
general purpose programmable I/O device which may be
used with many different microprocessors. There are 24 I/O
pins which may be individually programmed in two groups of
12 and used in three major modes of operation. The high
performance and industry standard configuration of the
82C55A make it compatible with the 80C86, 80C88 and
other microprocessors.
Static CMOS circuit design insures low operating power. The
Intersil advanced SAJI process results in performance equal
to or greater than existing functionally equivalent products at
a fraction of the power.
Ordering Information
PART
NUMBERS *
(Note)
PART
TEMP. PACKAGE
MARKING RANGE (°C) (Pb-free)
PKG.
DWG. #
CMP82C55AZ CMP82C55AZ 0 to 70 40 Ld PDIP** E40.6
CMS82C55AZ CMS82C55AZ 0 to 70 44 Ld PLCC N44.65
IMS82C55AZ IMS82C55AZ -40 to 85
CMQ82C55AZ CMQ82C55AZ 0 to 70 44 Ld MQFP Q44.10x10
IMQ82C55AZ IMQ82C55AZ -40 to 85
*Add “96” suffix to part number for tape and reel packaging.
**Pb-free PDIPs can be used for through hole wave solder processing
only. They are not intended for use in Reflow solder processing
applications.
NOTE: Intersil Pb-free plus anneal products employ special Pb-free
material sets; molding compounds/die attach materials and 100% matte
tin plate termination finish, which are RoHS compliant and compatible
with both SnPb and Pb-free soldering operations. Intersil Pb-free
products are MSL classified at Pb-free peak reflow temperatures that
meet or exceed the Pb-free requirements of IPC/JEDEC J STD-020.
Features
• Pb-Free Plus Anneal Available (RoHS Compliant)
(See Ordering Info)
• Pin Compatible with OKI MSM82C55A
- No Bus Hold Devices on any Port Pins
• 24 Programmable I/O Pins
• Fully TTL Compatible
• High Speed, No “Wait State” Operation with 8MHz 80C86
and 80C88
• Direct Bit Set/Reset Capability
• Enhanced Control Word Read Capability
• L7 Process
• 2.5mA Drive Capability on All I/O Ports
• Low Standby Power (ICCSB) . . . . . . . . . . . . . . . . . . .10µA
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005-2006. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.