ISL58344 Datasheet, PDF (1/2 Pages) Intersil Corporation – Quad Segment Photo Sensor IC Single +3.3V Power Supply

Quad Segment Photo Sensor IC
ISL58344
The ISL58344 photo sensor IC has a wide optical spectral
sensitivity from 400nm to 1000nm. It is good for multiple light
source applications, such as laser base projectors. The three sets
of gain registers can be used to adjust optical-to-electrical
conversion gain for each RED (R), GREEN (G), and BLUE (B) laser
or any wavelength in the spectral range for the application. The
ISL58344 is a single die device that has four identical photo
detectors arranged in segments that are optimized for laser
beam spot alignment. Quad segments can be used as a single
photo diode for optical power calibration and gamma correction.
The detectors can also be split into two sections with subtraction
signal output for laser beam position alignment. Beam detection
can also be used to compensate for MEMS scanning projector
geometric distortions and temperature distortions. Registers can
be updated in real time while device is in operation.
The ISL58344 can be put in sleep mode through serial interface,
where it consumes virtually no power. The ENA pin, when low, will
put the device in standby mode. Toggling the ENA pin Hi will turn
the device on quickly.
The ISL58344 operates from a single +3.3V supply. It is available
in a space-saving 9 pin glass top BGA package.
Related Literature
• See TB478 “PCB Assembly Guidelines for Shell-Op 3D Package”
Get Full Datasheet
Features
• Sensitive from 400nm to 1000nm with Patented Technology
for Improved Blue Photo Response
• Differential Voltage Output
• Internal Output Reference or External Output Reference
• Single +3.3V Power Supply
• Serial Interface for Gain Calibration
• Fast Settling Time <20ns
• Wide Signal Bandwidth >50MHz
• Wide Signal Gain Dynamic Range >25dB
• Sleep Mode for Conserving Power
• Quad PD Segments Provide Laser Beam Offset for Beam
Realignment Capability
• White Balance for LCoS and MEMS Systems
• Small 9-ball Optical Chip Scale Package (OCSP)
(2.2mmx2.2mm)
• Glass Top Package Compatible with Near UV and Blue LDs
• Intersil 3-wire SPI Interface
Applications
• Optical Power Monitoring
• Laser Based/LED Based Pico-Projectors
• Laser Based/LED Based projection TV
March 11, 2011
FN7524.0
Power Converter
Digital Circuits
MEMS H&V Driver
Power Converter
Raster Scan Image
Video
Front End
&
Video
Processor
MCU
MEMS
Digital
Controller
Horizontal
&
Vertical
Driver
Vertical
Horizontal
H Pos
V Pos
Horizontal
&
Vertical
Position
Detection
Pixel Data (RGB)
CLK
OEIC
ISL58344
Laser Diode Driver
FIGURE 1. APPLICATION BLOCK DIAGRAM
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas Inc. 2011. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.