ISL4241E Datasheet, PDF (1/14 Pages) Intersil Corporation – QFN Packaged, ±15kV ESD Protected, +2.7V to +5.5V, 10Nanoamp, 250kbps, +2.7V to +5.5V, 10Nanoamp, 250kbps,

®
Data Sheet
ISL4241E, ISL4243E
June 10, 2010
FN8037.7
QFN Packaged, ±15kV ESD Protected,
+2.7V to +5.5V, 10Nanoamp, 250kbps,
RS-232 Transmitters/Receivers
Intersil’s ISL4241E, ISL4243E devices are 2.7V to 5.5V
powered RS-232 transmitters/receivers which meet
ElA/TIA-232 and V.28/V.24 specifications, even at
VCC = 3.0V. Additionally, they provide ±15kV ESD protection
(IEC61000-4-2 Air Gap and Human Body Model) on
transmitter outputs and receiver inputs (RS-232 pins).
Targeted applications are PDAs, Palmtops, and notebook
and laptop computers where the low operational, and even
lower standby, power consumption is critical. Efficient
on-chip charge pumps, coupled with manual and automatic
power-down functions, reduce the standby supply current to
a 10nA trickle. Tiny 5mmx5mm Quad Flat No-Lead (QFN)
packaging and the use of small, low value capacitors ensure
board space savings as well. Data rates greater than
250kbps are guaranteed at worst case load conditions.
The ISL4241E, ISL4243E’s are 3 driver, 5 receiver devices
that, coupled with the 5x5 QFN package, provide the
industry’s smallest, lowest power complete serial port
suitable for PDAs, and laptop or notebook computers. The
32 Ld 5X5 QFN requires 60% less board area than a 28 Ld
TSSOP, and is nearly 20% thinner. The devices also include
a noninverting always-active receiver for “wake-up”
capability.
The ISL4243E features an automatic power-down function
that powers down the on-chip power-supply and driver
circuits. This occurs when an attached peripheral device is
shut off or the RS-232 cable is removed, conserving system
power automatically without changes to the hardware or
operating system. It powers up again when a valid RS-232
voltage is applied to any receiver input.
Table 1 summarizes the features of both the ISL4241E and
ISL4243E, while Application Note AN9863 summarizes the
features of each device comprising the 3V RS-232 family.
Features
• Pb-Free Available (RoHS compliant)
• Parameters Fully Specified for 10% Tolerance Supplies
and Full Industrial Temp Range
• Available in Small QFN (5mmx5mm) Package which is
60% Smaller than a 28 Lead TSSOP
• ESD Protection for RS-232 I/O Pins to ±15kV (IEC61000)
• Meets EIA/TIA-232 and V.28/V.24 Specifications at 3V
• RS-232 Compatible with V_CC = 2.7V
• On-Chip Voltage Converters Require Only Four External
0.1µF Capacitors
• Manual and Automatic Power-down Features
• Receiver Hysteresis For Improved Noise Immunity
• Guaranteed Minimum Data Rate . . . . . . . . . . . . . 250kbps
• Wide Power Supply Range . . . . . . Single +2.7V to +5.5V
• Low Supply Current in Power-down State . . . . . . . . .10nA
Applications
• Any Space Constrained System Requiring RS-232 Ports
- Battery Powered, Hand-Held, and Portable Equipment
- Laptop Computers, Notebooks
- PDAs and Palmtops, Data Cables
- Cellular/Mobile Phones, Digital Cameras, GPS
Receivers
Related Literature
• Technical Brief TB363 “Guidelines for Handling and
Processing Moisture Sensitive Surface Mount Devices
• ”Technical Brief TB379 “Thermal Characterization of
Packages for ICs”
• Technical Brief TB389 “PCB Land Pattern Design and
Surface Mount Guidelines for QFN Packages”
TABLE 1. SUMMARY OF FEATURES
PART NUMBER
ISL4241E
NO. OF
Tx.
3
NO. OF
Rx.
5
QFN PKG.
AVAILABLE?
YES
NO. OF
MONITOR Rx.
(R_OUTB)
2
ISL4243E
3
5
YES
1
DATA
RATE
(kbps)
250
250
Rx. ENABLE
FUNCTION?
YES
NO
READY
OUTPUT?
NO
NO
MANUAL
POWER-
DOWN?
YES
YES
AUTOMATIC
POWER-
DOWN
FUNCTION?
NO
YES
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2004, 2008, 2010. All Rights Reserved
All other trademarks mentioned are the property of their respective owners