ISL22329 Datasheet, PDF (1/13 Pages) Intersil Corporation – Dual Digitally Controlled Potentiometers XDCP

ISL22329
®
Dual Digitally Controlled Potentiometers (XDCP™)
Data Sheet
September 4, 2009
FN6330.2
Low Noise, Low Power, I²C^™ Bus, 128 Taps,
Wiper Only
The ISL22329 integrates two digitally controlled
potentiometers (DCP) and non-volatile memory on a
monolithic CMOS integrated circuit.
The digitally controlled potentiometers are implemented with
a combination of resistor elements and CMOS switches. The
position of the wipers are controlled by the user through the
I²C bus interface. Each potentiometer has an associated
volatile Wiper Register (WR) and a non-volatile Initial Value
Register (IVR) that can be directly written to and read by the
user. The contents of the WR controls the position of the
wiper. At power-up the device recalls the contents of the two
DCP’s IVR to the corresponding WRs.
The DCPs can be used as a voltage divider in a wide variety
of applications including control, parameter adjustments, AC
measurement and signal processing.
Pinout
ISL22329
(10 LD MSOP)
TOP VIEW
A2
1
SCL
2
SDA
3
GND
4
RW1
5
10 RW0
9
SHDN
8
V_CC
7
A1
6
A0
Features
• Two potentiometers in one package
• 128 resistor taps
• I²C serial interface
- Three address pins, up to eight devices/bus
• Non-volatile storage of wiper position
• Wiper resistance: 70Ω typical @ 3.3V
• Shutdown mode
• Shutdown current 5µA max
• Power supply: 2.7V to 5.5V
• 50kΩ or 10kΩ total resistance
• High reliability
- Endurance: 1,000,000 data changes per bit per register
- Register data retention: 50 years @ T < +55°C
• 10 Ld MSOP
• Pb-free (RoHS compliant)
Ordering Information
PART NUMBER
(Note)
PART MARKING
RESISTANCE OPTION
(kΩ)
TEMP. RANGE
(°C)
PACKAGE
(Pb-free)
PKG. DWG. #
ISL22329UFU10Z*
329UZ
50
-40 to +125
10 Ld MSOP
M10.118
ISL22329WFU10Z*
329WZ
10
-40 to +125
10 Ld MSOP
M10.118
*Add “-TK” suffix for tape and reel. Please refer to TB347 for details on reel specifications.
NOTE: These Intersil Pb-free plastic packaged products employ special Pb-free material sets, molding compounds/die attach materials, and 100%
matte tin plate plus anneal (e3 termination finish, which is RoHS compliant and compatible with both SnPb and Pb-free soldering operations).
Intersil Pb-free products are MSL classified at Pb-free peak reflow temperatures that meet or exceed the Pb-free requirements of IPC/JEDEC J
STD-020.
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) and XDCP are registered trademarks of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2006, 2009. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.