ISL1561 Datasheet, PDF (1/13 Pages) Intersil Corporation – 3 pin serial port interface

Fixed Gain Dual Port Class-G Differential xDSL Line
Driver
ISL1561
The ISL1561 is a fixed gain dual port class-G differential
amplifier designed for driving full rate ADSL2+ and VDSL2
signals at very low power dissipation. The driver runs on a
single +14V power supply and internally generates higher
supply voltages when needed to enable power efficient
operation for high peak-to-average ratio (PAR) ADSL2+ and
VDSL2 signals.
In ADSL2+ mode of operation with full 19.8dBm transmit
signal power across 100Ω line load, each port consumes only
520mW of power, while with 19.5dBm VDSL2 8b profile a port
consumes 610mW of power. In VDSL2 17a mode of operation
with 14.5dBm transmit power, a port will consume 411mW of
power. These typical power consumption figures account for
receiver hybrid loading effects and transformer losses.
The ISL1561 provides two ports of wideband, current feedback
amplifiers optimized for low power consumption in xDSL
systems. The drivers achieve an average upstream missing
band power ratio (MBPR) distortion of better than -64dBc
under 19.8dBm transmit signal power into 100Ω load. A three
pin serial interface is used to program an 8-bit internal register
to set each port’s supply current with 0.5mA step size. This
flexibility allows the DSP to optimize each port separately
during modem training.
The device is supplied in a thermally-enhanced small footprint
(4mmx4mm) 24 lead QFN package. The ISL1561 is specified
for operation over the full -40°C to +85°C industrial
temperature range and is Pb-free RoHS compliant.
Features
• Internal fixed gain of 11.6V/V to transformer (see Figure 3)
• 360mA output drive capability
• 41.8V_P-P differential output drive into 100Ω in class G mode
• VDSL2 8b profile MTPR of -64dBc
• VDSL2 17a profile MTPR of -60dBc
• ADSL2+, VDSL2 8b and 17a power consumption of 520mW,
610mW and 411mW respectively
• 8-bit programmable register to set supply current on each
port
• 3 pin serial port interface
Applications
• Dual port ADSL2+ and VDSL2 DSLAM
Alternate Part
• ISL1591 Class AB VDSL Driver
+14V
SCLK
SDATA
CS
SERIAL
BIAS
INTERFACE _CURRENT
SETTING
POWER MANAGEMENT
BOOST
AFE
INP
SWITCH SIGNAL
BOTH PORTS
SUPPLY
RAILS OF
LINE DRIVERS
ANALOG
INPUT
CLASS
AB
DRIVER
1 OF 2
PORTS
OUTPUT OF
DRIVER
FIGURE 1. BLOCK DIAGRAM
CPP
CPSW
CMM
CMSW
OUT
900
800
8b CLASS AB
700
17a CLASS AB
600
500
400
300
8b CLASS G
200
100
17a CLASS G
0
2
4
6
8 10 12 14 16 18 20
Tx POWER (dBm)
FIGURE 2. CLASS G+ vs CLASS AB DRIVER TOTAL POWER
February 26, 2013
1
FN7941.1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas LLC 2012, 2013. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.