IS-2100AEH Datasheet, PDF (1/2 Pages) Intersil Corporation – Radiation Hardened High Frequency Half Bridge Drivers

Radiation Hardened High Frequency Half Bridge
Drivers
IS-2100ARH, IS-2100AEH
The Radiation Hardened IS-2100ARH, IS-2100AEH are high
frequency, 130V Half Bridge N-Channel MOSFET Driver ICs,
which are functionally similar to industry standard 2110 types.
The low-side and high-side gate drivers are independently
controlled. This gives the user maximum flexibility in
dead-time selection and driver protocol.
In addition, the devices have on-chip error detection and
correction circuitry, which monitors the state of the high-side
latch and compares it to the HIN signal. If they disagree, a set
or reset pulse is generated to correct the high-side latch. This
feature protects the high-side latch from single event upsets
(SEUs).
Specifications for Rad Hard QML devices are controlled by the
Defense Logistics Agency Land and Maritime (DLA). The SMD
numbers listed here must be used when ordering.
Detailed Electrical Specifications for the IS-2100ARH,
IS-2100AEH are contained in SMD 5962-99536. A “hotlink” is
also provided on our website for downloading.
Ordering Information
ORDERING NUMBER
5962F9953602V9A
5962F9953602VXC
5962F9953602QXC
IS9-2100ARH/Proto
5962F9953603VXC
5962F9953603V9A
INTERSIL MKT. TEMP. RANGE
NUMBER
(°C)
IS0-2100ARH-Q
-55 to +125
IS9-2100ARH-Q
-55 to +125
IS9-2100ARH-8
-55 to +125
IS9-2100ARH/Proto -55 to +125
IS9-2100AEH-Q
-55 to +125
IS0-2100AEH-Q
-55 to +125
Features
• Electrically Screened to DLA SMD # 5962-99536
• QML Qualified per MIL-PRF-38535 Requirements
• Radiation Environment
- Maximum Total Dose. . . . . . . . . . . . . . . . . . . . . 300krad(SI)
- DI RSG Process Provides Latch-up Immunity
- SEU Rating . . . . . . . . . . . . . . . . . . . . . . . . . 82MeV/mg/cm²
- Vertical Device Architecture Reduces Sensitivity to Low
Dose Rates
• Bootstrap Supply Max Voltage to 150V
• Drives 1000pF Load at 1MHz with Rise and Fall Times of
30ns (Typ)
• 1.5A (Typ) Peak Output Current
• Independent Inputs for Non-Half Bridge Topologies
• Low DC Power Consumption. . . . . . . . . . . . . . . . . 60mW (Typ)
• Operates with V_DD = V_CC Over 12V to 20V Range
• Low-side Supply Undervoltage Protection
Applications
• High Frequency Switch-Mode Power Supplies
• Drivers for Inductive Loads
• DC Motor Drivers
Pin Configuration
IS-2100ARH, IS-2100AEH
FLATPACK (CDFP4-F16)
TOP VIEW
LO
COM
V_CC
NC
NC
VS
VB
HO
1
16
2
15
3
14
4
13
5
12
6
11
7
10
8
9
NC
V_SS
LIN
SD
HIN
V_DD
NC
NC
August 28, 2012
1
FN9037.2
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas Inc. 2002, 2012. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.