HS-82C85RH_07 Datasheet, PDF (1/18 Pages) Intersil Corporation – Radiation Hardened CMOS Static Clock Controller/Generator

®
Data Sheet
HS-82C85RH
April 20, 2007
FN3044.3
Radiation Hardened CMOS Static Clock
Controller/Generator
The Intersil HS-82C85RH is a high performance, radiation
hardened CMOS Clock Controller/Generator designed to
support systems utilizing radiation hardened static CMOS
microprocessors such as the HS-80C86RH. The
HS-82C85RH contains a crystal controlled oscillator, reset
pulse conditioning, halt/restart logic, and divide-by-256
circuitry. These features provide the means to stop the
system clock, stop the clock oscillator, or run the system at a
low frequency (CLK/256), enhancing control of static system
power dissipation and allowing system shut-down during
periods of external stress.
Static CMOS circuit design insures low operating power and
permits operation with an external frequency source from
DC to 15MHz. Crystal controlled operation to 15MHz is
guaranteed with the use of a parallel, fundamental mode
crystal and two small load capacitors. Outputs are
guaranteed compatible with both CMOS and TTL
specifications. The Intersil hardened field CMOS process
results in performance equal to or greater than existing
radiation resistant products at a fraction of the power.
Specifications for Rad Hard QML devices are controlled
by the Defense Supply Center in Columbus (DSCC). The
SMD numbers listed here must be used when ordering.
Detailed Electrical Specifications for these devices are
contained in SMD 5962-95820. A “hot-link” is provided
on our homepage for downloading.
http://www.intersil.com/military/
Features
• Electrically Screened to SMD # 5962-95820
• QML Qualified per MIL-PRF-38535 Requirements
• Radiation Hardened
- Total Dose. . . . . . . . . . . . . . . . . . . . . 100 krad(Si) (Max)
- Transient Upset . . . . . . . . . . . . . . . . . . . .>10⁸ rad(Si)/s
- Latch Up Free EPI-CMOS
• Very Low Power Consumption
• Pin Compatible with NMOS 8285 and Intersil 82C85
• Generates System Clocks for Microprocessors and
Peripherals
• Complete Control Over System Clock Operation for Very
Low System Power
- Stop-Oscillator
- Stop-Clock
- Low Frequency (Slo) Mode
- Full Speed Operation
• DC to 15MHz Operation (DC to 5MHz System Clock)
• Generates Both 50% and 33% Duty Cycle Clocks
(Synchronized)
• Uses Either Parallel Mode Crystal Circuit or External
Frequency Source
• Hardened Field, Self-Aligned, Junction Isolated CMOS
Process
• Single 5V Supply
• Military Temperature Range . . . . . . . . . . . -55°C to +125°C
Ordering Information
ORDERING NUMBER
INTERNAL
MKT. NUMBER
5962R9582001VJC
HS1-82C85RH-Q
5962R9582001VXC
HS9-82C85RH-Q
5962R9582001QJC
HS1-82C85RH-8
5962R9582001QXC HS9-82C85RH-8
PART MARKING
Q 5962R95 82001VJC
Q 5962R95 82001VXC
Q 5962R95 82001VJC
Q 5962R95 82001VXC
TEMP. RANGE
(°C)
PACKAGE
-55 to +125 24 Ld SBDIP
-55 to +125 24 Ld Flatpack
-55 to +125 24 Ld SBDIP
-55 to +125 24 Ld Flatpack
PKG. DWG. #
D24.6
K24.A
D24.6
K24.A
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2000, 2007. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.