HS-4424DRH Datasheet, PDF (1/15 Pages) Intersil Corporation – Dual, Noninverting Power MOSFET Radiation Hardened Drivers

DATASHEET
Dual, Noninverting Power MOSFET Radiation Hardened
Drivers
HS-4424DRH, HS4424DEH
The radiation hardened HS-4424 family are noninverting, dual,
monolithic high-speed MOSFET drivers designed to convert low
voltage control input signals into higher voltage, high current
outputs. The HS-4424DRH, HS-4424DEH are fully tested
across the 8V to 18V operating range.
The inputs of these devices can be directly driven by the
HS-1825ARH PWM device or by our ACS/ACTS and HCS/HCTS
type logic devices. The fast rise times and high current outputs
allow very quick control of high gate capacitance power
MOSFETs in high frequency applications.
The high current outputs minimize power losses in MOSFETs by
rapidly charging and discharging the gate capacitance. The
output stage incorporates a low voltage lockout circuit that
puts the outputs into a three-state mode when the supply
voltage is below its Undervoltage Lockout (UVLO) threshold
voltage.
Constructed with Intersil’s dielectrically isolated Rad Hard
Silicon Gate (RSG) BiCMOS process, these devices are immune
to single event latch-up and have been specifically designed to
provide highly reliable performance in harsh radiation
environments.
TABLE 1. HS4424 PRODUCT FAMILY SPECIFIC UVLO Vth
PART NUMBER
UVLO (V)
HS-4424RH
<10
HS-4424EH
HS4424BRH
<7.5
HS4424BEH
HS4424DRH
<8
HS4424DEH
Features
• Electrically screened to DLA SMD# 5962-99560
• QML qualified per MIL-PRF-38535 requirements
• Latch-up immune
• Radiation environment
• High dose rate (50-300rad(Si)/s). . . . . . . . . . . . . 300krad(Si)
- Low dose rate (0.01rad(Si)/s) . . . . . . . . . . . . . 50krad(Si)*
*Limit established by characterization
• I_PEAK. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >2A (minimum)
• Matched rise and fall times (C_L = 4300pF). . 75ns (maximum)
• Low voltage lockout feature . . . . . . . . . . . . . . . . . . . . . . . . <8V
• Wide supply voltage range . . . . . . . . . . . . . . . . . . . . 8V to 18V
• Propagation delay . . . . . . . . . . . . . . . . . . . . 250ns (maximum)
• Consistent delay times with V_CC changes
• Low power consumption
- 40mW with inputs high
- 20mW with inputs low
• Low equivalent input capacitance . . . . . . . . . . 3.2pF (typical)
• ESD protected. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >4kV
Applications
• Switching power supplies
• DC/DC converters
• Motor controllers
+8V TO +18V
VCC
PWM
IN A
CONTROLLER
HS-1825ARH ^{IN B}
OUT A
OUT B
HS-4424D
GND
FIGURE 1. TYPICAL APPLICATION
October 15, 2015
1
FN8747.2
7.7
UVLO_f
7.6
UVLO_r
7.5
7.4
7.3
7.2
-55
25
125
TEMPERATURE (°C)
FIGURE 2. UNDERVOLTAGE LOCKOUT vs TEMPERATURE
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2015. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.