|
HS-2600RH Datasheet, PDF (1/5 Pages) Intersil Corporation – Radiation Hardened Wideband, High Impedance Operational Amplifier | |||
|
Data Sheet
HS-2600RH
August 1999 File Number 3650.1
Radiation Hardened Wideband, High
Impedance Operational Ampliï¬er
HS-2600RH is a radiation hardened internally compensated
bipolar operational ampliï¬er that features very high input
impedance coupled with wideband AC performance. The
high resistance of the input stage is complemented by low
offset voltage (4mVmax at 25oC for HS-2600RH) and low
bias and offset current (10nA max at 25oC for HS-2600RH)
to facilitate accurate signal processing. Offset voltage can be
reduced further by means of an external nulling
potentiometer. The 4V/µs minimum slew rate at 25oC and
the minimum open loop gain of 100kV/V at 25oC enables the
HS-2600RH to perform high gain ampliï¬cation of fast,
wideband signals. These dynamic characteristics, coupled
with fast settling times, make these ampliï¬ers ideally suited
to pulse ampliï¬cation designs as well as high frequency or
video applications. The frequency response of the ampliï¬er
can be tailored to exact design requirements by means of an
external bandwidth control capacitor. Other high
performance designs such as high gain, low distortion audio
ampliï¬ers, high-Q and wideband active ï¬lters and high
speed comparators, are excellent uses of this part.
Speciï¬cations for Rad Hard QML devices are controlled
by the Defense Supply Center in Columbus (DSCC). The
SMD numbers listed here must be used when ordering.
Detailed Electrical Speciï¬cations for these devices are
contained in SMD 5962-95671. A âhot-linkâ is provided
on our homepage for downloading.
www.intersil.com/spacedefense/space.asp
Ordering Information
ORDERING NUMBER
INTERNAL
MKT. NUMBER
5962D9567101VPA
HS7-2600RH-Q
5962D9567101VPC
HS7B-2600RH-Q
TEMP. RANGE
(oC)
-55 to 125
-55 to 125
Features
⢠Electrically Screened to SMD # 5962-95671
⢠QML Qualiï¬ed per MIL-PRF-38535 Requirements
⢠High Input Impedance . . . . . . . . . . . . . . . . . 100M⦠(Min)
500M⦠(Typ)
⢠High Slew Rate. . . . . . . . . . . . . . . . . . . . . . . . 3V/µs (Min)
7V/µs (Typ)
⢠Low Input Bias Current . . . . . . . . . . . . . . . . . . 10nA (Max)
1nA (Typ)
⢠Low Input Offset Current (HS-2600RH) . . . . . . 4mV (Max)
⢠Wide Unity Gain Bandwidth . . . . . . . . . . . . . .12MHz (Typ)
⢠Output Short Circuit Protection
⢠Total Gamma Dose. . . . . . . . . . . . . . . . . . . . . 10kRAD(Si)
Applications
⢠Video Ampliï¬er
⢠Pulse Ampliï¬er
⢠High-Q Active Filters
⢠High Speed Comparators
⢠Low Distortion Oscillators
Pinout
HS7-2600RH (CERDIP) GDIP1-T8
OR
HS7B-2600RH (SBDIP) CDIP2-T8
TOP VIEW
BAL 1
-IN 2
â
+IN 3
+
V- 4
8 COMP
7 V+
6 OUT
5 BAL
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999
|
▷ |