|
HS-139RH-T Datasheet, PDF (1/2 Pages) Intersil Corporation – Radiation Hardened Quad Voltage Comparator | |||
|
Data Sheet
HS-139RH-T
July 1999 File Number 4646.1
Radiation Hardened Quad Voltage
Comparator
Intersilâs Satellite Applications FlowTM (SAF) devices are fully
tested and guaranteed to 100kRAD total dose. These QML
Class T devices are processed to a standard ï¬ow intended
to meet the cost and shorter lead-time needs of large
volume satellite manufacturers, while maintaining a high
level of reliability.
The Radiation Hardened HS-139RH-T consists of four
independent single or dual supply voltage comparators on a
single monolithic substrate. The common mode input voltage
range includes ground, even when operated from a single
supply, and the low supply current make these comparators
suitable for low power applications. These types were
designed to directly interface with TTL and CMOS.
The HS-139RH-T is fabricated on our dielectrically isolated
Rad Hard Silicon Gate (RSG) process, which provides an
immunity to Single Event Latch-up and the capability of
highly reliable performance in any radiation environment.
Speciï¬cations
Speciï¬cations for Rad Hard QML devices are controlled by
the Defense Supply Center in Columbus (DSCC). The SMD
numbers listed below must be used when ordering.
Detailed Electrical Speciï¬cations for the HS-139RH-T
are contained in SMD 5962-98613. A âhot-linkâ is
provided on our homepage with instructions for
downloading.
www.intersil.com/spacedefense/newsafclasst.asp
Intersilâ Quality Management Plan (QM Plan), listing all
Class T screening operations, is also available on our
website.
www.intersil.com/quality/manuals.asp
Ordering Information
ORDERING NUMBER PART NUMBER
TEMP. RANGE
(oC)
5962R9861301TCC HS1-139RH-T
-55 to 125
5962R9861301TXC
HS9-139RH-T
-55 to 125
NOTE: Minimum order quantity for -T is 150 units
through distribution, or 450 units direct.
Features
⢠QML Qualiï¬ed Per MIL-PRF-38535 Requirements
⢠Radiation Environment
- Latch-up Free Under Any Conditions
- Total Dose. . . . . . . . . . . . . . . . . . . . . . . 3 x 105 RAD(Si)
- SEU LET . . . . . . . . . . . . . . . . . . . . . . . 20MEV/cm2/mg
⢠100V Output Voltage Withstand Capability
⢠Differential Input Voltage Range Equal to the Supply
Voltage
⢠Input Offset Voltage (VIO). . . . . . . . . . . . . . . . . 2mV(max)
⢠Quiescent Supply Current . . . . . . . . . . . . . . . . 2mA(max)
Applications
⢠Pulse Generators
⢠Timing Circuitry
⢠Level Shifting
⢠Analog to Digital Conversion
Pinouts
HS-139RH-T (SBDIP), CDIP2-T14
TOP VIEW
OUT 2 1
OUT 1 2
V+ 3
- IN 1 4
+ IN 1 5
- IN 2 6
+ IN 2 7
14 OUT 3
13 OUT 4
12 GND
11 + IN 4
10 - IN 4
9 + IN 3
8 - IN 3
HS-139RH-T (FLATPACK), CDFP3-F14
TOP VIEW
OUT 2
OUT 1
V+
- IN 1
+ IN 1
- IN 2
- IN 2
1
14
2
13
3
12
4
11
5
10
6
9
7
8
OUT 3
OUT 4
GND
+ IN 4
- IN 4
+ IN 3
- IN 3
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
Satellite Applications Flow⢠(SAF) is a trademark of Intersil Corporation.
|
▷ |