|
HS-1145RH Datasheet, PDF (1/9 Pages) Intersil Corporation – Radiation Hardened, High Speed, Low Power, Current Feedback Video Operational Amplifier with Output Disable | |||
|
Data Sheet
HS-1145RH
August 1999 File Number 4227.1
Radiation Hardened, High Speed, Low
Power, Current Feedback Video
Operational Ampliï¬er with Output Disable
The HS-1145RH is a high speed, low power current
feedback ampliï¬er built with Intersilâs proprietary
complementary bipolar UHF-1 (DI bonded wafer) process.
These devices are QML approved and are processed and
screened in full compliance with MIL-PRF-38535.
This ampliï¬er features a TTL/CMOS compatible disable
control, pin 8, which when pulled low, reduces the supply
current and forces the output into a high impedance state.
This allows easy implementation of simple, low power video
switching and routing systems. Component and composite
video systems also beneï¬t from this op ampâs excellent gain
ï¬atness, and good differential gain and phase speciï¬cations.
Multiplexed A/D applications will also ï¬nd the HS-1145RH
useful as the A/D driver/multiplexer.
Speciï¬cations for Rad Hard QML devices are controlled
by the Defense Supply Center in Columbus (DSCC). The
SMD numbers listed here must be used when ordering.
Detailed Electrical Speciï¬cations for these devices are
contained in SMD 5962-96830. A âhot-linkâ is provided
on our homepage for downloading.
http://www.intersil.com/spacedefense/space.htm
Ordering Information
ORDERING NUMBER
INTERNAL
MKT. NUMBER
5962F9683001VPA
HS7-1145RH-Q
5962F9683001VPC
HS7B-1145RH-Q
TEMP. RANGE
(oC)
-55 to 125
-55 to 125
Features
⢠Electrically Screened to SMD # 5962-96830
⢠QML Qualiï¬ed per MIL-PRF-38535 Requirements
⢠Low Supply Current . . . . . . . . . . . . . . . . . . . . 5.9mA (Typ)
⢠Wide -3dB Bandwidth. . . . . . . . . . . . . . . . . .360MHz (Typ)
⢠High Slew Rate. . . . . . . . . . . . . . . . . . . . . .1000V/µs (Typ)
⢠Excellent Gain Flatness (to 50MHz). . . . . . ±0.07dB (Typ)
⢠Excellent Differential Gain . . . . . . . . . . . . . . . 0.02% (Typ)
⢠Excellent Differential Phase . . . . . . . . 0.03 Degrees (Typ)
⢠High Output Current . . . . . . . . . . . . . . . . . . . .60mA (Typ)
⢠Output Enable/Disable Time . . . . . . . . . 180ns/35ns (Typ)
⢠Total Gamma Dose. . . . . . . . . . . . . . . . . . . . 300kRAD(Si)
⢠Latch Up . . . . . . . . . . . . . . . . . . . . . None (DI Technology)
Applications
⢠Multiplexed Flash A/D Driver
⢠RGB Multiplexers/Preamps
⢠Video Switching and Routing
⢠Pulse and Video Ampliï¬ers
⢠Wideband Ampliï¬ers
⢠RF/IF Signal Processing
⢠Imaging Systems
Pinout
HS-1145RH
GDIP1-T8 (CERDIP)
OR CDIP2-T8 (SBDIP)
TOP VIEW
NC 1
-IN 2 -
+IN 3 +
V- 4
8 DISABLE
7 V+
6 OUT
5 NC
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999
|
▷ |