HS-1135RH_09 Datasheet, PDF (1/9 Pages) Intersil Corporation – Radiation Hardened, High Speed, Low Power Current Feedback Amplifier

®
Data Sheet
April 6, 2009
HS-1135RH
FN4099.3
Radiation Hardened, High Speed, Low
Power Current Feedback Amplifier with
Programmable Output Limiting
The HS-1135RH is a radiation hardened, high speed, low
power current feedback amplifier built with Intersil’s
proprietary complementary bipolar UHF-1 (DI bonded wafer)
process. They are QML approved and processed in full
compliance with MIL-PRF-38535. This amplifier features
user programmable output limiting, via the V_H and V_L pins.
The HS-1135RH is the ideal choice for high speed, low
power applications requiring output limiting (e.g., flash A/D
drivers), especially those requiring fast overdrive recovery
times. The limiting function allows the designer to set the
maximum and minimum output levels to protect downstream
stages from damage or input saturation. The
sub-nanosecond overdrive recovery time ensures a quick
return to linear operation following an overdrive condition.
Component and composite video systems also benefit from
this op amp’s performance, as indicated by the gain flatness,
and differential gain and phase specifications.
Specifications for Rad Hard QML devices are controlled
by the Defense Supply Center in Columbus (DSCC). The
SMD numbers listed here must be used when ordering.
Detailed Electrical Specifications for these devices are
contained in SMD 5962-96767. A “hot-link” is provided
on our website for downloading.
Pinouts
HS-1135RH
GDIP1-T8 (CERDIP)
OR CDIP2-TI (SBDIP)
TOP VIEW
NC 1
-IN 2 _-
+IN 3 ⁺
V- 4
8 V_H
7 V+
6 OUT
5 V_L
Features
• Electrically Screened to SMD # 5962-96767
• QML Qualified per MIL-PRF-38535 Requirements
• User Programmable Output Voltage Limiting
• Fast Overdrive Recovery . . . . . . . . . . . . . . . . . <1ns (Typ)
• Low Supply Current . . . . . . . . . . . . . . . . . . . . 6.9mA (Typ)
• Wide -3dB Bandwidth. . . . . . . . . . . . . . . . . .360MHz (Typ)
• High Slew Rate . . . . . . . . . . . . . . . . . . . . .1200V/µs (Typ)
• High Input Impedance . . . . . . . . . . . . . . . . . . . 2MΩ (Typ)
• Excellent Gain Flatness (to 50MHz). . . . . . ±0.07dB (Typ)
• Total Gamma Dose . . . . . . . . . . . . . . . . . . . 300kRAD(Si)
• Latch Up. . . . . . . . . . . . . . . . . . . . . None (DI Technology)
Applications
• Flash A/D Driver
• Video Switching and Routing
• Pulse and Video Amplifiers
• Wideband Amplifiers
• RF/IF Signal Processing
• Imaging Systems
HS-1135RH
CDFP3-F14 (FLATPACK)
TOP VIEW
NC
1
14
NC
NC
2
13
V_H
-IN
3
12
V+
+IN
4
11
OUT
NC
5
10
V_L
NC
6
9
NC
V-
7
8
NC
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 1999, 2009. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.