|
HIP1015 Datasheet, PDF (1/10 Pages) Intersil Corporation – Power Distribution Controllers | |||
|
TM
Data Sheet
HIP1015, HIP1016
May 2000 File Number 4778.1
Power Distribution Controllers
The HIP1015 and HIP1016 are hot swap power controllers.
The HIP1015 is targeted for a +12V bus whereas the
HIP1016 is targeted for +5V applications. Each has an
undervoltage (UV) monitoring and reporting with a threshold
level ~17% lower than the nominal +12V and +5V.
The HIP1015 has an integrated charge pump allowing
control of up to a +12V bus using an external N-channel
MOSFET. The HIP1016 can also be used to control much
higher positive or negative voltages in a low side controller
conï¬guration. Both the HIP1015 and HIP1016 feature
programmable Overcurrent (OC) detection, current limiting
regulation with time delay to latch off and soft start.
Ordering Information
PART NUMBER
HIP1015CB
HIP1015CB-T
HIP1016CB
HIP1016CB-T
TEMP.
RANGE (oC)
PACKAGE
0 to 85 8 Lead SOIC
0 to 85
8 Lead SOIC
Tape and Reel
0 to 85 8 Lead SOIC
0 to 85
8 Lead SOIC
Tape and Reel
PKG.
NO.
M8.15
M8.15
M8.15
M8.15
Application One - High Side Controller
+ LOAD -
1
8
2
7
HIP1015
3
6
4
5
PWRON
PGOOD
OC
+12V
Features
⢠HOT SWAP Single Power Distribution Control (HIP1015
for 12V, HIP1016 for 5V and Low Side Switch)
⢠Undervoltage Monitoring and Notiï¬cation
⢠Overcurrent Fault Isolation
⢠Programmable Current Regulation Level
⢠Programmable Current Limit Time to Latch-Off
⢠Rail to Rail Common Mode Input Voltage Range
(HIP1015)
⢠Internal Charge Pump Allows the use of N-channel
MOSFET (HIP1015)
⢠Undervoltage and Overcurrent Latch Indicators
⢠Adjustable Turn-On Ramp
⢠Protection During Turn On
⢠Two Levels of Overcurrent Detection Provide Fast
Response to Varying Fault Conditions
⢠Less Than 1µs Response Time to Dead Short
Applications
⢠Power Distribution Control
⢠Hot Plug Components and Circuitry
⢠High Side Low Voltage (< +15V) Switching
⢠Low Side High Voltage (> +15V, Negative V) Switch
Pinout
HIP1015, HIP1016 (SOIC)
TOP VIEW
ISET 1
ISEN 2
GATE 3
VSS 4
8 PWRON
7 PGOOD
6 CTIM
5 VDD
Application Two - Low Side Controller
+VBUS
LOAD
12V REG
HIP1016
PWRON
OC
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil and Design is a trademark of Intersil Corporation. | Copyright © Intersil Corporation 2000
|
▷ |