HI-546_15 Datasheet, PDF (1/25 Pages) Intersil Corporation – Single 16 and 8, Differential 8-Channel and 4-Channel CMOS Analog MUXs with Active Overvoltage Protection

Data Sheet
HI-546, HI-547, HI-548, HI-549
October 1, 2015
FN3150.6
Single 16 and 8, Differential 8-Channel
and 4-Channel CMOS Analog MUXs with
Active Overvoltage Protection
The HI-546, HI-547, HI-548 and HI-549 are analog
multiplexers with active overvoltage protection and
guaranteed r_ON matching. Analog input levels may greatly
exceed either power supply without damaging the device or
disturbing the signal path of other channels. Active
protection circuitry assures that signal fidelity is maintained
even under fault conditions that would destroy other
multiplexers.
Analog inputs can withstand constant 70V_P-P levels with
15V supplies. Digital inputs will also sustain continuous
faults up to 4V greater than either supply. In addition, signal
sources are protected from short circuiting should
multiplexer supply loss occur. Each input presents 1k of
resistance under this condition. These features make the
HI-546, HI-547, HI-548 and HI-549 ideal for use in systems
where the analog inputs originate from external equipment
or separately powered circuitry. All devices are fabricated
with 44V Dielectrically Isolated CMOS technology. The
HI-546 is a single 16-Channel, the HI-547 is an 8-Channel
differential, the HI-548 is a single 8-Channel and the HI-549
is a 4-Channel differential device. If input overvoltage
protection is not needed the HI-506/507/508/509
multiplexers are recommended. For further information see
Application Notes AN520 and AN521.
For MIL-STD-883 compliant parts, request the HI-546/883,
HI-547/883, HI-548/883 and HI-549/883 datasheets.
Features
• Analog Overvoltage Protection. . . . . . . . . . . . . . . . . . 70V_P-P
• No Channel Interaction During Overvoltage
• Guaranteed r_ON Matching
• Maximum Power Supply . . . . . . . . . . . . . . . . . . . . . . 44V
• Break-Before-Make Switching
• Analog Signal Range . . . . . . . . . . . . . . . . . . . . . . . . 15V
• Access Time (Typical) . . . . . . . . . . . . . . . . . . . . . . . 500ns
• Standby Power (Typical) . . . . . . . . . . . . . . . . . . . . 7.5mW
• Pb-Free Plus Anneal Available (RoHS Compliant)
Applications
• Data Acquisition
• Industrial Controls
• Telemetry
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas LLC
Copyright © Intersil Americas LLC 2003, 2005, 2015. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.