EL5397A Datasheet, PDF (1/13 Pages) Intersil Corporation – Triple 200MHz Fixed Gain Amplifier with Enable

®
NOT ^{RECOMMESNEDEEDELF5O3R06NEW DESIGNS}
Data Sheet
January 22, 2004
EL5397A
FN7197
Triple 200MHz Fixed Gain Amplifier with
Enable
The EL5397A is a triple channel, fixed
gain amplifier with a bandwidth of
200MHz, making these amplifiers ideal
for today’s high speed video and monitor applications. The
EL5397A features internal gain setting resistors and can be
configured in a gain of +1, -1 or +2. The same bandwidth is
seen in both gain-of-1 and gain-of-2 applications.
With a supply current of just 4mA per amplifier and the ability
to run from a single supply voltage from 5V to 10V, these
amplifiers are also ideal for hand held, portable or battery
powered equipment.
The EL5397A also incorporates an enable and disable
function to reduce the supply current to 100µA typical per
amplifier. Allowing the CE pin to float or applying a low logic
level will enable the amplifier.
For applications where board space is critical, the EL5397A
is offered in the 16-pin QSOP package, as well as a 16-pin
SO (0.150"). The EL5397A is specified for operation over the
full industrial temperature range of -40°C to +85°C.
Pinout
EL5397A
[16-PIN SO (0.150"), QSOP]
TOP VIEW
INA+ 1
CEA 2
-
+
VS- 3
+
CEB 4
-
INB+ 5
NC 6
+
CEC 7
-
INC+ 8
16 INA-
15 OUTA
14 VS+
13 OUTB
12 INB-
11 NC
10 OUTC
9 INC-
Features
• Gain selectable (+1, -1, +2)
• 200MHz -3dB bandwidth (A_V = 1, 2)
• 4mA supply current (per amplifier)
• Single and dual supply operation, from 5V to 10V or ±2.5V
to ±5V
• Fast enable/disable
• Available in 16-pin QSOP package
• Single (EL5197) available
• 400MHz, 9mA products available (EL5196 & EL5396)
Applications
• Battery-powered equipment
• Hand-held, portable devices
• Video amplifiers
• Cable drivers
• RGB amplifiers
• Test equipment
• Instrumentation
• Current to voltage converters
Ordering Information
PART NUMBER
PACKAGE
TAPE &
REEL
EL5397ACS
16-Pin SO (0.150")
-
EL5397ACS-T7 16-Pin SO (0.150") 7”
EL5397ACS-T13 16-Pin SO (0.150") 13”
EL5397ACU
16-Pin QSOP
-
EL5397ACU-T13 16-Pin QSOP
13”
PKG. NO.
MDP0027
MDP0027
MDP0027
MDP0040
MDP0040
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2004. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.
All other trademarks mentioned are the property of their respective owners.