|
CD54AC374 Datasheet, PDF (1/1 Pages) Intersil Corporation – Octal D-Type Flip-Flop, Three-State Positive-Edge Triggered, Non-Inverting | |||
|
SEMICONDUCTOR
June 1997
COMPLETE DATA SHEET
COMING SOON!
CD54AC374/3A
CD54ACT374/3A
Octal D-Type Flip-Flop, Three-State
Positive-Edge Triggered, Non-Inverting
Description
Functional Diagram
The CD54AC374/3A and CD54ACT374/3A are octal D-type,
D0
three-state, positive-edge triggered ï¬ip-ï¬ops that utilize the
Harris Advanced CMOS Logic technology. The eight ï¬ip-
D1
ï¬ops enter data into their registers on the LOW-to-HIGH
transition of the clock (CP). The Output Enable (OE) controls
D2
the three-state outputs and is independent of the register
D3
operation. When the Output Enable (OE) is HIGH, the out-
puts are in the high-impedance state.
D4
The CD54AC374/3A and CD54ACT374/3A are supplied in
D5
20 lead dual-in-line ceramic packages (F sufï¬x).
D6
ACT INPUT LOAD TABLE
D7
INPUT
UNIT LOAD (NOTE 1)
D, OE
0.7
OE
CP
CP
1.17
NOTE:
1. Unit load is âICC limit speciï¬ed in DC Electrical Speciï¬cations
Table, e.g., 2.4mA Max at +25oC.
Q0
Q1
Q2
Q3
Q4
Q5
Q6
Q7
GND = 10
VCC = 20
Absolute Maximum Ratings
DC Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +6V
DC Input Diode Current, IIK
For VI < -0.5V or VI > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . . .±20mA
DC Output Diode Current, IOK
For VO < -0.5V or VO > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC Output Source or Sink Current, Per Output Pin, IO
For VO > -0.5V or VO < VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC VCC or GND Current, ICC or IGND
For Up to 4 Outputs Per Device, Add ±25mA For Each
Additional Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±100mA
Power Dissipation Per Package, PD
TA = -55oC to +100oC (Package F) . . . . . . . . . . . . . . . . . . 500mW
TA = +100oC to +125oC (Package F) . . . . . . . . Derate Linearly at
8mW/oC to 300mW
Operating Temperature Range, TA
Package Type F . . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Storage Temperature, TSTG . . . . . . . . . . . . . . . . . . -65oC to +150oC
Lead Temperature (During Soldering)
At Distance 1/16in. ± 1/32in. (1.59mm ± 0.79mm)
From Case For 10s Max . . . . . . . . . . . . . . . . . . . . . . . . . . +265oC
Unit Inserted Into a PC Board (Min Thickness 1/16in., 1.59mm)
With Solder Contacting Lead Tips Only. . . . . . . . . . . . . . . +300oC
CAUTION: Stresses above those listed in âAbsolute Maximum Ratingsâ may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this speciï¬cation is not implied.
Recommended Operating Conditions
Supply Voltage Range, VCC
Unless Otherwise Speciï¬ed, All Voltages Referenced to GND
TA = Full Package Temperature Range
CD54AC Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5V to 5.5V
CD54ACT Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.5V to 5.5V
DC Input or Output Voltage, VI, VO. . . . . . . . . . . . . . . . . . 0V to VCC
Operating Temperature, TA . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Input Rise and Fall Slew Rate, dt/dv
at 1.5V to 3V (AC Types) . . . . . . . . . . . . . . . . . . . 0ns/V to 50ns/V
at 3.6V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 20ns/V
at 4.5V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 10ns/V
CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper I.C. Handling Procedures.
Copyright © Harris Corporation 1994
1
File Number 3910
|